C9800 AP CDP

[Rajesh Kongath]

Hi

Is there any way to display cdp information of APs on c9800 (17.6.3) controller in GUI? I am looking for the command output of "sh ap cdp neighbors" in the GUI. 

AirOS based WLCs had an option to view this on GUI Home> Network summary > Access point view - I am looking for similar option on catalyst based WLCs

TIA - Rajesh

[Leo Laohoo]

There is a "Make a Wish" option on the 9800 GUI page. 

Alternatively, reach out to your Cisco AM/SE/PSS and ask them to create a PER in your behalf.

Good luck.

[Arshad Safrulla · Accepted solution]

You may navigate as shown in the above screenshot