Cisco embedded wireless controller multicast enable

[FCE]

Hi All ,

I have a Cisco AP model C9120AXI-E with embedded wireless controller v17.3.1 .

Does anyone know how I can enable multicast on cisco embedded wireless controller or is there any way to enable it?

Thanks for any help

[Sandeep Choudhary]

I think its similar to 9800 series WLC:

Navigate to:  Configuration > Services > Multicast

Regards

Dont forget to rate helpful posts

[FCE]

unfortunately the option is not available in the menu

Regards

[Sandeep Choudhary]

can you try from CLI, using this command:

AP(config)# wireless multicast

[FCE]

Thanks other idea ?

I have tried and is enabled but there is something missing and does not work 

[Arshad Safrulla]

All the EWC AP's are in Flex mode, so you need to enable multicast routing at your switch level or upstream devices (Client is bridged to the AP). 

[FCE]

multicast is enabled in my switch.

if did not understand correctly , do you have an instructions or  a youtube video for it ?

[patoberli]

I don't think that EWC fully supports multicast on 17.3.

I found this here for Apple Bonjour: https://www.cisco.com/c/en/us/td/docs/wireless/controller/ewc/17-3/config-guide/ewc_cg_17_3/m_local_area_bonjour_ewc_ap_mode.html

And here: https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/q-and-a-c67-743152.html

[FCE]

I have tried different software versions also with 17.06.01b it does not work too

[patoberli]

Yeah I'm pretty sure that EWC doesn't support the full multicast stack yet. There might be some undocumented features in the CLI, but I think only the stuff in my previously linked document is available.

[FCE]

yes you're right

I could not find anything on the internet

[Rich R]

According to https://www.cisco.com/c/en/us/td/docs/wireless/access_point/feature-matrix/ap-feature-matrix.html#_Toc87523896 EWC and WLC should have multicast feature parity for flexconnect so if it's not working it's a bug and you'll need a TAC case.

Regarding the GUI - make sure you login as admin - I've seen some menu's disappear when not using the admin user even though the user should have all/max priv (I think it's a bug but haven't bothered to look into it any deeper).

[FCE]

Thank you for your search,

I am logged in as admin but I can't find the multicast option under service and in the CLI the the known commands don't work.