cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
340
Views
1
Helpful
5
Replies

Configure AP domain-name by CLI on AireOS WLC

LAN team
Level 1
Level 1

Hello,

Is there a way to configure domain-name on a specific access-poin by CLI on WLC 5520 ?

Something like "config ap xxxxxx" 

Thank you.

 

1 Accepted Solution

Accepted Solutions

LAN team
Level 1
Level 1

config ap static-IP add domain <Cisco AP>/All <domain-name>

CLI Commands  [Cisco 5500 Series Wireless Controllers] - Cisco Systems

 

View solution in original post

5 Replies 5

marce1000
VIP
VIP

 

           - No   ,that is not  possible , 

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

It is...

config ap static-IP add domain <Cisco AP>/All <domain-name>

CLI Commands  [Cisco 5500 Series Wireless Controllers] - Cisco Systems

Rich R
VIP
VIP

What are you hoping to achieve by that?

You could set the domain-name in your DHCP but I still don't see what purpose that would serve.

LAN team
Level 1
Level 1

config ap static-IP add domain <Cisco AP>/All <domain-name>

CLI Commands  [Cisco 5500 Series Wireless Controllers] - Cisco Systems

 

Good to know the command - I wasn't aware of that.
We use DHCP pretty much for all our APs and never needed a domain name in those rare cases where we use static IPs.
Of course that requires that you use a static IP for the AP.

Review Cisco Networking for a $25 gift card