Could not apply interface override

[nn7963]

We have just implemented a 5508 controller pair with MSE, Prime, and ISE. The system is working well, but I keep getting the following message in the log of the controller:

[ERROR] apf_policy.c 3383: Could not apply interface override:
  source Override Summation, interface '30', vlanId: 0x1e

Our APs are all set for FlexConnect so it seems to be reporting an issue applying the vlan override on an AP, but I have no reported issues of this not working. I cannot find this error anywhere in a reference guide. VLAN 30 is our local flexconnect user subnet.

2nd question regards the apf_policy.c 3383. Does this refer to a specific AP? If so is there some cross reference for this 3383 number to an actual AP in my system. I can't find any correlation. I've looked at MAC address, SN, etc.. and I don't see any correlation.

[davidfunmi1]

hi,

I am having the same error message on flex 7510 controllers as well.

Any ideas please, much appreciated

[Scott Fella]

Might be a cosmetic bug to be honest if everything is working fine.  You can open a TAC case so they can identify it as a bug or tell you if there is already a bud id.

-Scott

[Saurav Lodh]

Vlan1d:0x1e i.e 30 , can you set no vlan override to vlan 30 in the
ISE and test if the error is thrown again

[davidfunmi1]

Saurav,

where in ISE can i make this change?

[gohussai]

i think you better approach TAC to rectify the issue.