09-08-2011 05:14 PM - edited 07-03-2021 08:44 PM
Hai all..
i have one AP LWAPP .. the problem is, i cannot configure this AP trough CLI. when i tyr put the command, it was appear the error "ERROR!!! command is Disabled"..this AP is new AP that i recieved from my vendor..this AP not configured yet before this and not connect to controller yet. so how to enable this command and how to reset that AP? i hope you all can help me in troubleshoot this metter....
09-08-2011 05:18 PM
Here is the Bug that we are hiting!!
Check the work around!!
Pleasedont forget to rate the usefull posts!!
Regards
Surendra
09-08-2011 05:19 PM
u can think of this post as well!!
https://supportforums.cisco.com/thread/2055309
Regards
Surendra
09-08-2011 08:56 PM
ERROR!Command is disabled
What are you trying to configure? This is "typical" if your LWAP/CAPWAP booted using the LWAP/CAPWAP IOS. If you let the AP boot using the "rcv" file then you can do some limited stuff like configure IP address, WLC management IP address, hostname, etc.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide