ERROR!Command is disabled

[Muhamad Badulisham Md Desa]

Hai all..

i have one AP LWAPP .. the problem is, i cannot configure this AP trough CLI. when i tyr put the command, it was appear the error "ERROR!!! command is Disabled"..this AP is new AP that i recieved from my vendor..this AP not configured yet before this and not connect to controller yet. so how to enable this command and how to reset that AP? i hope you all can help me in troubleshoot this metter....

[Surendra BG]

Here is the Bug that we are hiting!!

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsy17745

Check the work around!!

Pleasedont forget to rate the usefull posts!!

Regards

Surendra

[Surendra BG]

u can think of this post as well!!

https://supportforums.cisco.com/thread/2055309

Regards

Surendra

[Leo Laohoo]

ERROR!Command is disabled

What are you trying to configure?  This is "typical" if your LWAP/CAPWAP booted using the LWAP/CAPWAP IOS.  If you let the AP boot using the "rcv" file then you can do some limited stuff like configure IP address, WLC management IP address, hostname, etc.