Wireless

Hi All,I note that in the WLC v6.0 config guide support for EAP-FAST is listed under the workgroup bridge configuration section.Has anyone been successfull in getting this working ?  or have a config example ?I've had limited success on setting up a ...

Hi,I have issue for converting lwap to autonomous for lap1131 model.According to cisco document, i have followed the below procedure :I  have formatted the flash as well as followed the same procedureformat flash:resetThen type in:set IP-ADDR 10.0.0....

Anyone has documentation on how to setup the 5508 Series LAN wireless controller. The online documentation are not details.What different between Service Interface IP and  Management interface IP. The device IP is using what type service or managemen...

Dear all,I'm getting the following error message when doing a debug client on the controller:EAPOL-key M2 with invalid WPA IE received from mobile 00:21:e8:12:76:cbThe client off course can not connect to the network sucessfully then....Has anyone se...

I have about 10 Cisco 1200s.  They are spaced out pretty well throughout my building.  There does not seem to be that many dead spots that I have noticed.  My question is about clients accessing the APs.  We have nearly 175 computers on a one time.  ...

HiWe have recently upgraded the software on our two WLC 4404 from software release 4.0.xxx to 4.2.xxx to  6.1.199.4 and lastly to version 7.0.98.0.We could access the WLC's GUI's using https when it was on version 4.0.xxx. When we did the upgrades fr...

I have a tale of woe for you who may be considering Hybrid REAP with local switching.My client has a varied configuration, but the requirements basically screamed HREAP with local switching.  They have 15 sites, had already purchased a single WLC 440...

a customer has wireless LAN controller with version 4.2.205.0 and i want to upgrade it to version 7.do i need to upgrade the controller to intermediate version or i cant directly upgrade it.

I was using Document 100787 as a guide.1. I have  1252 & 1142 AP's  connected to the Wism (6.0.188.0 code)2.  FWSM I have a 4402 (6.0.188.0 ) appliance connected as my anchor.3. ACS is ver 4.2All of my wireless networks function as expected. I see th...

I need to bridge from our office to our shop that is around 800 feet away.  Here are the DetailsI need the 2.4 ghz antenna for client access (Iphones are not compatiable with 802.11a)The locations are 800 feet away but are line of sight.I need to use...

I have a 2125 WLC. I have some 1242 Access Point registered to the WLC. The problem is that the handheld connects to the WLC but sometimes it shows that it has lost wireless signal. Users say that this happens when they go from one site to another. I...

I currently have DCHP server set up on my new 1141N. Everything works great, but I wanted to know if it were possible to make the DHCP server only hand out ip addresses on the wireless connection? Currently the AP is giving out ip addresses from the ...

Hi, We Have a WLC-4402 controller with LWAPPs and different VLANs and SSIDs. I've configured a Linksys WET200 to associate to one of the SSIDs.On the WLC I can see, that the WET200 is associated to one Wlan.Then I connect one computer with a static I...

Wireless Client 10.150.0.12 pings 172.16.50.100 (Windows 2003 Server with dual NICs on same subnet, same default gateway), reply is from 172.16.50.101, will the WLC drop the return traffic to 10.150.0.12?We notice wireless clients can't ping this dua...