flash and ram in WLC

[didik.indra]

hi,

i am looking around hwo to know the flash and ram installed in WLC 4402 ?

try looking any command, sh ver not there. even in WCS.

any idea?

thanks..

[Serge Yasmine · Accepted solution]

Hi,

wlc doesn't have the sh flash command like other Cisco platforms. Anyhow if this might help you, you can do

show boot (to see images that are sitting on the wlc)

show memory statistics (to see the memory)

thanks

Serge

[didik.indra]

hi sarge,

thanks for the answer. i think  that explain why there is no such info in inventory by WCS.

[kasemov]

Dear All,

Can you please help me finding the right command to :-

- show memory size of all AP's installed through WLC , i'm using version 8.3 , i did run " show mesh ap summary " but it only shows mesh AP's . what about root AP's ?

Best Regards,

Kasem Klot

[patoberli]

Please open a new thread for this. In any case, I don't think this is possible, but it's normally also not required.