Heatmap

[bluesea2010]

Hi,

When we generate heatmap , Do we  select only 5 ghz frequency or we have to design for 2.4 also ?

The below parameter is ideal for an education institutaion 

Requirement 100Mbps@Everywhere

Coverage requirement >=-65dBm
Capacity requirement   Phone*8Mbps(720P Video)
Concurrency rate 70%
SINR requirement >=9dB
Coverage compliance 98%
Capacity compliance 97%
SINR compliance 54%

Thanks

[Leo Laohoo]

---

@bluesea2010 wrote:
The below parameter is ideal for an education institutaion 

---

Always design for 5.0 Ghz, 40 Mhz channel width, however, for a school/university, put an AP in every classroom.  

[Rich R]

> Do we  select only 5 ghz frequency or we have to design for 2.4 also ?

Depends on customer requirement.  But your 2.4 coverage is generally better than 5.0 so as Leo says design for 5.  Customer will usually expect to see the heatmaps for both bands.