how to check that antennas are connected to access point?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-21-2015 07:19 AM - edited 07-05-2021 04:07 AM
Which command(s) can show whether antennas are connected to access point and to which transmitter on access point (2.4 Ghz vs 5Ghz)?
If found that #show controllers d0 or d1 gives this output
....
Antenna: external, Gain: Allowed 4, Reported 4, In Use 4
.....
However the result looks not always correct. (sometimes controller without antenna showed the same as with antenna).
Please give advise(s).
- Labels:
-
Aironet Access Points
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2015 06:06 PM
No command available. The output of the "sh controllers" is statically assigned and can be changed manually.
