how to make password recovery AIR-SAP2602E-A-K9 cisco

[Rafael Mauricio Navarrete Echegoyen]

I have a problem ,i dont know if possible to make password recovery a cisco AIR-SAP2602E-A-K9. can you help me please.

[gohussai]

Check the following post for Password recovery.

https://supportforums.cisco.com/document/31571/cisco-aironet-access-points-ios-recovery

NotE:-  Mostly we use ROMMON for recovery of AP as mentioned. Default user/pass is "cisco".

[Rafael Mauricio Navarrete Echegoyen]

thanks my friend, the problem is that APAIR-SAP2602E-A-K9 cisco is working y my job but i dont know the username and password for this I NEED to know if possible to make password recovery.

[gohussai]

Your welcome :).

[Rafael Mauricio Navarrete Echegoyen]

thanks my friend, the problem is that APAIR-SAP2602E-A-K9 cisco is working y my job but i dont know the username and password for this I NEED to know if possible to make password recovery without lost the configuration saved?

[Venkatesh Attuluri]

Hello , do you have console access to AP , if you have physical access to AP then there is a reset button on the AP. Hold it for 30seconds, and you will be able to login with default : Cisco/Cisco,

[Prakash Parvathala]

Password Recovery Procedure for Cisco Aironet Equipment

http://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/9215-pwrec-2.html

[mohanak]

MODE Button Setting : http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-3_7_JA/configuration/guide/i1237sc/s37trb.html

The lightweight access point MODE button is configured from your Cisco Wireless LAN Controller. Use these controller CLI commands to view and configure the MODE button:

1) config ap rst-button enable <access-point-name>/all

2) config ap rst-button disable <access-point-name>/all

3) show ap config general <access-point-name>

(Where access-point-name is the name that identifies the access point on the 
ocntroller.)