https access for WLC

[vishalpatil86]

hi,

we use cisco 4400 WLC. We want to move it from http to https/

how can we do it?

Also, how can assign public IP to wlc so that we can access it tru internet?

[Surendra BG · Accepted solution]

Enable HTTPS on the WLC..

config network secureweb enable

assign the public IP to the WLC management int and the switch should be able to route the IP then possible or may be, u can go for 1:1 mapping between ur internal and external ip mapping for WLC ip and the external IP so that u can access.. May be for ur second question security firewall section is the right forum to get the right resourse..

Please dont forget to rate the usefull posts!!

Regards

Surendra

[vishalpatil86]

ok thanks.

will wlc get restarted after enabling it?

and where can enable it from gui  mode?

[Surendra BG · Accepted solution]

yes enabling HTTPS requires Reboot i guess... from the GUI its

WLC >> Management >> HTTP-HTTPS

Regards

Surendra

[vishalpatil86]

when i enabled it from cli mode, it asked me to reboot.

but when i did the same from gui, it didnt ask for the reboot.

[Surendra BG · Accepted solution]

oh!! but we need to reboot

Regards

Surendra

[vishalpatil86]

can i have that security firewall link?

[Surendra BG · Accepted solution]

https://supportforums.cisco.com/community/netpro/security/firewall

[vishalpatil86]

thank you

[George Stefanick]

Surendra already anwsered your question. But i wanted to piggy back on to his response. If you forget how to config HTTP / HTTPS i blogged about this feature and you can always reference this in yhe future if needed ...

http://www.my80211.com/cisco-wlc-cli-commands/2010/1/22/wlc-how-to-enable-webmode-http-or-secureweb-https.html