cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1168
Views
0
Helpful
9
Replies

https access for WLC

vishalpatil86
Beginner
Beginner

hi,

we use cisco 4400 WLC. We want to move it from http to https/

how can we do it?

Also, how can assign public IP to wlc so that we can access it tru internet?

4 Accepted Solutions

Accepted Solutions

Surendra BG
Cisco Employee
Cisco Employee

Enable HTTPS on the WLC..

config network secureweb enable

assign the public IP to the WLC management int and the switch should be able to route the IP then possible or may be, u can go for 1:1 mapping between ur internal and external ip mapping for WLC ip and the external IP so that u can access.. May be for ur second question security firewall section is the right forum to get the right resourse..

Please dont forget to rate the usefull posts!!

Regards

Surendra

Regards
Surendra BG

View solution in original post

yes enabling HTTPS requires Reboot i guess... from the GUI its

WLC >> Management >> HTTP-HTTPS

Regards

Surendra

Regards
Surendra BG

View solution in original post

oh!! but we need to reboot

Regards

Surendra

Regards
Surendra BG

View solution in original post

9 Replies 9

Surendra BG
Cisco Employee
Cisco Employee

Enable HTTPS on the WLC..

config network secureweb enable

assign the public IP to the WLC management int and the switch should be able to route the IP then possible or may be, u can go for 1:1 mapping between ur internal and external ip mapping for WLC ip and the external IP so that u can access.. May be for ur second question security firewall section is the right forum to get the right resourse..

Please dont forget to rate the usefull posts!!

Regards

Surendra

Regards
Surendra BG

ok thanks.

will wlc get restarted after enabling it?

and where can enable it from gui  mode?

yes enabling HTTPS requires Reboot i guess... from the GUI its

WLC >> Management >> HTTP-HTTPS

Regards

Surendra

Regards
Surendra BG

when i enabled it from cli mode, it asked me to reboot.

but when i did the same from gui, it didnt ask for the reboot.

oh!! but we need to reboot

Regards

Surendra

Regards
Surendra BG

can i have that security firewall link?

thank you

Surendra already anwsered your question. But i wanted to piggy back on to his response. If you forget how to config HTTP / HTTPS i blogged about this feature and you can always reference this in yhe future if needed ...

http://www.my80211.com/cisco-wlc-cli-commands/2010/1/22/wlc-how-to-enable-webmode-http-or-secureweb-https.html

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: