08-08-2006 09:59 PM - edited 07-04-2021 12:48 PM
Hi
I want to limit the amount of MAC address associated with the access-point.
10x
Solved! Go to Solution.
08-09-2006 04:50 AM
Hi Naor,
If you are looking at allowing only so many users to associate to an AP at one time you can use the max-Associations command.
If you are trying to allow only certain users (mac) to access the AP you can use mac filters. Examples for both are listed below;
This example shows how to:
Name an SSID
Configure the SSID for RADIUS accounting
Set the maximum number of client devices that can associate using this SSID to 15
Assign the SSID to a VLAN
AP# configure terminal
AP(config)# interface dot11radio 0
AP(config-if)# ssid batman
AP(config-ssid)# accounting accounting-method-list
AP(config-ssid)# max-associations 15
AP(config-ssid)# vlan 3762
AP(config-ssid)# end
From this doc;
Configuring and Enabling MAC Address Filters
MAC address filters allow or disallow the forwarding of unicast and multicast packets either sent from or addressed to specific MAC addresses. You can create a filter that passes traffic to all MAC addresses except those you specify, or you can create a filter that blocks traffic to all MAC addresses except those you specify. You can apply the filters you create to either or both the Ethernet and radio ports and to either or both incoming and outgoing packets.
From this doc;
Hope this helps!
Rob
Please remember to rate helpful posts.......
08-09-2006 04:50 AM
Hi Naor,
If you are looking at allowing only so many users to associate to an AP at one time you can use the max-Associations command.
If you are trying to allow only certain users (mac) to access the AP you can use mac filters. Examples for both are listed below;
This example shows how to:
Name an SSID
Configure the SSID for RADIUS accounting
Set the maximum number of client devices that can associate using this SSID to 15
Assign the SSID to a VLAN
AP# configure terminal
AP(config)# interface dot11radio 0
AP(config-if)# ssid batman
AP(config-ssid)# accounting accounting-method-list
AP(config-ssid)# max-associations 15
AP(config-ssid)# vlan 3762
AP(config-ssid)# end
From this doc;
Configuring and Enabling MAC Address Filters
MAC address filters allow or disallow the forwarding of unicast and multicast packets either sent from or addressed to specific MAC addresses. You can create a filter that passes traffic to all MAC addresses except those you specify, or you can create a filter that blocks traffic to all MAC addresses except those you specify. You can apply the filters you create to either or both the Ethernet and radio ports and to either or both incoming and outgoing packets.
From this doc;
Hope this helps!
Rob
Please remember to rate helpful posts.......
08-09-2006 08:56 PM
Thank you very much.
It Worked
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide