No SSID during installation in Mobility Express

[gogokokoko1966]

i heard  Mobility Express is so easy for user(not engineer) to install 
in my case , Cisco think i am neither user and engineer just monster or alien ?

here is Korea, and i have running of 2 wireless cisco ap 3700
I have been stuck so strongly during the installation of 3800
No shown ssid or cisco provision  ...... 
i found out below message during the booting 
------ below -----------
[*05/10/2024 12:24:40.3496] DOT11_TXP[0]:Domain configured: 0 class:A
[*05/10/2024 12:24:40.4330] DOT11_TXP[2]:Domain configured: 0 class:A
[*05/10/2024 12:24:40.5135] DOT11_TXP[0]:Domain configured: 41 class:B
[*05/10/2024 12:24:40.9962] DOT11_TXP[1]:Domain configured: 41 class:B
[*05/10/2024 12:24:41.0878] USB Device Disconnected from the AP
[*05/10/2024 12:24:41.5044] DOT11_TXP[2]:Domain configured: 41 class:B
[*05/10/2024 12:24:42.8061] DOT11_DRV[0]: Stopped Radio 0
[*05/10/2024 12:24:42.8311] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 6
[*05/10/2024 12:24:43.7721] DOT11_DRV[1]: Stopped Radio 1
[*05/10/2024 12:24:43.7987] DOT11_DRV[1]: DOT11_DRV[1]: set_channel Channel set to 36
[*05/10/2024 12:24:45.5755] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 1
[*05/10/2024 12:24:46.3137] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 1
[*05/10/2024 12:24:46.3317] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 1

What is that ???? is that an eatable things ???
Is there anyone who can cook for me ???? 

[marce1000]

 - Have a checkup of the mobility express AP's configuration using ; WirelessAnalyzer input (procedure) for AireOs controllers
   and feed the output from that into Wireless Config Analyzer

   M.

[Rich R]

I have never used the airprovision SSID. I always use console and SSH to do base config from CLI.
Once you have base config done you can connect to GUI over LAN and finish your setup.

So I suggest erase the config using mode button https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-2/b_Mobility_Express_Deployment_guide/b_Mobility_Express_Deployment_guide_chapter_0110.html#:~:text=Hold%20the%20button%20depressed%20for,will%20broadcast%20the%20CiscoAirProvision... or via CLI https://community.cisco.com/t5/wireless-mobility-knowledge-base/how-to-reset-a-wireless-lan-controller-wlc-to-factory-defaults/ta-p/3122866 and then use CLI for base config and then access the GUI via LAN to finish your config.