03-30-2022 04:52 AM
i have to wlc at my company but i don't know witch one is the primary WLC
can you help with commands to check that.
thanks
Solved! Go to Solution.
03-30-2022 07:44 AM - edited 03-30-2022 07:44 AM
If you have new catalyst 9800 controllers, then you can use the following CLI commands to verify.
9800 WLC-1# show redundancy
9800 WLC-1# show chassis
From Web interface (GUI) Navigate to Monitoring > System > Redundancy on the controller Web UI. The Redundancy States page is displayed as shown below
- CJ
/**Please rate all useful responses**/
03-30-2022 04:56 AM - edited 03-30-2022 04:58 AM
You can check command level :
>show redundancy summary
you can view :
Local State =ACTIVE
Peer State = STANDBY HOT
GUI
03-30-2022 06:06 PM
Thanks that was Helpfull, my WLC Don't have summary command
03-30-2022 07:44 AM - edited 03-30-2022 07:44 AM
If you have new catalyst 9800 controllers, then you can use the following CLI commands to verify.
9800 WLC-1# show redundancy
9800 WLC-1# show chassis
From Web interface (GUI) Navigate to Monitoring > System > Redundancy on the controller Web UI. The Redundancy States page is displayed as shown below
- CJ
/**Please rate all useful responses**/
03-30-2022 06:07 PM
Thanks that was Helpfull, the show redundancy & show chassis Working my WLC but the is the SSO means?
03-30-2022 07:53 AM - edited 03-30-2022 07:55 AM
(Cisco Controller) >show ap config 802.11a AP02
Cisco AP Identifier.............................. 0
Cisco AP Name.................................... AP02
Country code..................................... US - United States
Regulatory Domain allowed by Country............. 802.11bg:-A 802.11a:-A
AP Regulatory Domain............................. Unconfigured
Switch Port Number .............................. 1
MAC Address...................................... 00:0b:85:18:b6:50
IP Address Configuration......................... DHCP
IP Address....................................... 1.100.49.240
IP NetMask....................................... 255.255.255.0
Gateway IP Addr.................................. 1.100.49.1
CAPWAP Path MTU.................................. 1485
Telnet State..................................... Disabled
Ssh State........................................ Disabled
Cisco AP Location................................ default-location
Cisco AP Group Name.............................. default-group
Primary Cisco Switch............................. Cisco_32:ab:63<- here appear
Primary Cisco Switch IP Address.................. Not Configured
Secondary Cisco Switch...........................
Secondary Cisco Switch IP Address................ Not Configured
Tertiary Cisco Switch............................
Tertiary Cisco Switch IP Address................. Not Configured
select any AP MAC and use it as command above you will get the primary WLC.
03-30-2022 06:09 PM
show ap config worked on my WLC but the 802.11a AP02 Don't maybe i need permission
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide