primary WLC

[muneef81]

i have to wlc at my company but i don't know witch one is the primary WLC
can you help with commands to check that.

thanks

[balaji.bandi]

You can check command  level :

>show redundancy summary

you can view :

Local State =ACTIVE
Peer State = STANDBY HOT

GUI

[muneef81]

Thanks that was Helpfull, my WLC Don't have summary command 

[jagan.chowdam · Accepted solution]

If you have new catalyst 9800 controllers, then you can use the following CLI commands to verify.

9800 WLC-1# show redundancy 

9800 WLC-1# show chassis 

From Web interface (GUI) Navigate to Monitoring > System > Redundancy on the controller Web UI. The Redundancy States page is displayed as shown below

 

- CJ

/**Please rate all useful responses**/

[muneef81]

Thanks that was Helpfull, the show redundancy & show chassis Working my WLC but the is the SSO means?

[MHM Cisco World]

(Cisco Controller) >show ap config 802.11a AP02

Cisco AP Identifier.............................. 0

Cisco AP Name.................................... AP02

Country code..................................... US  - United States

Regulatory Domain allowed by Country............. 802.11bg:-A     802.11a:-A

AP Regulatory Domain............................. Unconfigured

Switch Port Number .............................. 1

MAC Address...................................... 00:0b:85:18:b6:50

IP Address Configuration......................... DHCP

IP Address....................................... 1.100.49.240

IP NetMask....................................... 255.255.255.0

Gateway IP Addr.................................. 1.100.49.1

CAPWAP Path MTU.................................. 1485

Telnet State..................................... Disabled

Ssh State........................................ Disabled

Cisco AP Location................................ default-location

Cisco AP Group Name.............................. default-group

Primary Cisco Switch............................. Cisco_32:ab:63<- here appear 

Primary Cisco Switch IP Address.................. Not Configured

Secondary Cisco Switch...........................

Secondary Cisco Switch IP Address................ Not Configured

Tertiary Cisco Switch............................

Tertiary Cisco Switch IP Address................. Not Configured

select any AP MAC and use it as command above you will get the primary WLC.

[muneef81]

show ap config worked on my WLC but the 802.11a AP02  Don't maybe i need permission