cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1270
Views
0
Helpful
5
Replies

WCS Client Reports not Consistent

bdubrow
Level 1
Level 1

I am trying to determine how many 802.11b clients I have on my network so I can deside whether to turn off the protocol.  When I run the Client Summary report I get 26 for Number of Users.  However, when I run the Client Count:Daily Stats I only get 14 802.11b clients.  I am including all controllers in each of the reports.  I would expect these two reports to report the same numbers.

5 Replies 5

Surendra BG
Cisco Employee
Cisco Employee

Hi,

Client Count report will provide us the Active Clients on your network.. Where in the Summary will provide the total clients in that time slot.

Regards

Surendra

Regards
Surendra BG

Thank you for your response.

If the reporting period is the same, for instance Last Hour, shouldn't the numbers be the same?

What version of WCS are you running?

What version of WLC code and controller do you have?

The WCS reads the number every 15 minutes and calculates the difference by comparing it to the prior polling period.

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0clientmgmt.html#wp1110112

Version of WCS is 7.0.164.0

Version of Controllers is 7.0.98.0

Go to WCS --> Configure --> Controllers ---> and verify that all the controllers are synced to identical. If there is a mis-match, please refresh the config from the controller using the "Select Command" and "Refresh Config from Controller" after selecting all the ip address/name of controllers. And rerun the reports afterwards.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card