Wireless clients cannot access WLC Management interface..

[Anvar Mohammed]

wireless clients can ping wlc management ip but can not access controller web interface,  

management via wireless clients are allowed at wlc confgiuration, 

i can access it through dynamic interface,, but not through management ip

attached sh-run config

thanks,

anvar

[Stephen Rodriguez]

This is a bad thing?

What is the issue, do you want your clients to be able to manage the WLC?

Steve

[Anvar Mohammed]

i had implemented more than 20 controllers, were i didn't find this case before, so i just need to know why it should not work.

basically i don't need wireless clients to access WLC management interface,, but why it is not working ??? while i can ping it,, but no SSH or GUI

thanks,

anvar 

[rajesh.netratrk]

Just came across same scenario!

Access to WLC management interface from its own wireless clients is blocked by default. But it can be enabled manually,

Management-->Mgmt via Wireless (on left side)---> click the check box on page to enable (self explanatory)

[Daniel Ordóñez Flores]

Hi there.
I can't see you file, one question your WLC is in HA SSO mode?

[singhmanaspratap]

Hi,

As per config attached Mgmt via wireless is enabled , secure webmode is also enabled. Please try accessing WLC via https:// , http would not work. 

By the way Cisco would not recommend enabling Mgmt via wireless access unless there is a requirement from the Customer.

Thanks and regards,

Manas Pratap Singh 

[Vengatesa Prasath]

Have you tested with client on same subnet of wireless management interface? if so what is the status.

Is it possible to collect uplink capture from WLC? Working and non working scenario (working: When tried with dynamic inerface && Non working: When tried with management interface)