ASR9001 XR span sub interface to a pseudo wire (xconnect)

[tim.banks]

I am trying to find out if a asr9001 xr router can span a sub interface - layer 3 with an IP on it across a psuedo wire (xconnect connection ).

The config will be something like GigabitEthernet0/11/0/1.150

monitor-session pw-span-test

destination pseudowire

exit

monitor-l2vpn
pw-class class1
encapsulation mpls
xconnect group g1
p2p x1
monitor-session pw-span-test
neighbor 2.2.2.2 pw-id 1
pw-class classsession pw-span-test

[M02@rt37 · Accepted solution]

Hello @tim.banks 

Do you see use case here ? 

https://community.cisco.com/t5/service-providers-knowledge-base/asr9000-xr-how-to-use-port-spanning-or-port-mirroring/ta-p/3108031

[tim.banks]

many thanks, I did see this but didnt any direct mention of sub interfaces but I think it is possble because it accepts the commands.

[M02@rt37]

You're so welcome @tim.banks 

I think so yes.