Application Networking

Hi,I urgently need some help/advice on this issue, I have 2 ACE units (4710's) for our development environment, one with 0.5GB licence and the other one has the default 1GB licence (which is not applied). We need to connect these in a redundant manne...

Hi all,i hope i can find some help here within the forums. we ran into the following issue during a migration from foundry to the ACE-20 loadbalancers:ACE: with normal TCP probing on (example) port 7525 the ACE opens the socket, waits for the 3 way h...

Hi guys.I would like to know if I can migrate the config from ACE20 to ACE30 (last software) without any issue.I don't have any ACE30 to test Thanks a lot!

I have a pair of ACE 4710's that I am deploying within a datacenter.  The primary and secondary ACE appliances have identical configurations except for the IP addressing and priorities for FT.  The FT peer is going into a TL error state.  On the prim...

I'm having trouble with the functionality of backup servers in a serverfarm.Lets say I have three rservers in a serverfarm. Each rserver has a backup-server assigned to it. When a probe detects that one of the three nodes failed, the ACE puts the bac...

Hi, I am using WaaS for a long time now. With the new appnav module on the waas box, i am little confused about how to deploy. I have two WAN router connected to two firewalls in HA through L2 switches. I have two WaaS boxes in-line between the L2 sw...

Instructions on the upgrade page says:Instructions on how to apply the firmware update are posted on cisco.com together with the firmware in the file named L4_15427_FIRMWARE.pdf, which you can see after you click the Download link for the firmware.Ho...

I have one sticky group for multiple vservers and within each vserver is a different serverfarm with the same IPs but each server farm has a different probe.  Now if you look in the sticky table there will  be only once entry if my sticky is by sourc...

Hello,I'm new on ACE technologies , I would like to know how to configure a redirection on the ACE from HTTP to HTTPS using specific URLexample http://test.domain.com to https://test.domain.com, the SSL certificates were installed on the servers.Than...

Hi all , One of my WAVE-274 has this alarm :CMS status is offline.It appears offline on the central manager GUI but it is reachable by Telnet . This is the message I get when logging :System Initialization Finished.Disk based software not installed.S...

We have to use no normalization, no icmp-guard on ACE 5(2.0) to allow a One-Arm config to allow asymmetric traffic, i.e. everything of some rservers needs to go through the alias ip.Now this works but the connection table fills up pretty quickly and ...

Hi all,I have Ace 4710 version A4.1.1 and I am experiencing interesting problem with GUI and SSH reachability. I am unable to connect to management vlan3000. Interesting is that I can ping from ACE to network but unable to ping or SSH or HTTPS to ACE...