Application Networking

Cisco CSS flow idle timeout not working as expected ?

Hi,I have a CSS 11503 with a basic content rule for TCP 10000 going to a few backend servers. I was looking into the default timeout values for flows and when testing using telnet the flow didn't terminate as expected?For example, i have no 'timeout ...

ACE and the app_offline.htm ASP File

We are using the app_offline.htm file to take servers down for maintainence. I know we can manually take the RSERVER out of service, but the actuall objective is to keep the server up, and let the ASP page return the message to user. So the app_off...

Resolved! ACE - peer probes

Hi,We have a scenario where we PBR certain certain source IP`s back into the ACE to perform server NAT`ing. This is routed into the ACE via a alias IP.Problem we have is this breaks probes on the back up ACE as we health check the same IP`s for a inb...

Resolved! loadbalance for servers thats belongs from different Vlan

Hi,We are using FWSM and ACE module in our switch. We have to configure our new application in cisco ACE. Our exiciting servers and vip are in vlan5 and new servers and vips are in vlan 6. vlan 6 is defined in FWSM. We have craeated one interface vla...

alarms on WAE 512

Hello,Just got few alarms in one of WAE's saying router unreachable.I put the right wccp passwords, reset the cms tables and database, bounced the device but still no good. It can register with the CM but there is no traffic going through.Major Alarm...

ACE http https rewrite/redirect on same port

I am trying to do the following:http://test.foo.com:8000 -> https://test.foo.com:8000I am able to get redirection to work if the ports are different. For example, I am able to get http://test.foo.com:8000 to redirect to https://test.foo.com:8010. T...

Virtual Server on Wave Device

I have started leaning on the virtual blade in the wave device, and have run out of space. I looked at the virtual server and it was setup with only a 30 gb hard drive. How do I find out what the actual disk space is on the wave device? Also if it...

Resolved! ACE FT GROUP.

Hi,What is the standard design for FT group for multiple context. Should we have just two FT group or seperate FT group for each context.The doubt behind is that -Suppose i have 4 context A,B,C,D. Context A& B assigned to FT group 1 and C & D assig...

Reuse of context in ACE module

Hi all, just have a question about som reuse of resources in a ACE module context. I don't want to make a new context, and can reuse most of the existing configuration in one of my context. The config is not complex and difficult, but I'm not sure ...

CISCO WAVE 274- K9 INTERFACES IN BY PASS MODE

Dear All,kindly proffer solution. My Cisco WAVE 274-K9 DEVICE WAN AND LAN interfaces are in by pass mode what should i do to get this device up and running ?Jude

ACE 4710 deny SYN-ACK routing without SYN before?

Hi there,I've one behaviour on ace, than I can not understand...We've one interface on the ACE which is connected to a firewall via switch.In the same vlan is a serverfarm.net e.g. 172.16.10.0/24the server's gateway is the ACE (172.16.10.1)the ACE's ...

ACE: probe timers

Hi,I've general question about ACE probe timers. I've following probe setup:probe https probe:1061 port 1061 interval 34 passdetect interval 17 open 1 ACE# sh probe probe:1061detail probe : probe:1061 type : HTTPS state : ACTIV...

Cisco ACE and IIS Virtual Directories

Hello All,I have the Load Balancing between to servers working correctly except for on thing. If I enter www.domainname.com\apps into the browser it will returns a 302 page, but if I enter www.domainname.com\apps\ the page will Pull up. Is there a wa...

ACE 4710 problem from server vlan

HelloI have configured load balancing for a small server farm of 2 oracle ERP servers ( servers accepting web requests on port 8000)Design is routed mode where I have a client vlan and a server vlan , real servers default gateway is set to the alias ...

PBR in ACE4710 or in a 6500?

Hello,We are in the idea of performing PBR for traffic that enters 4 interfaces and needs to be policy based routed at L4 (IP addresses and ports).What are the pro's and cons' of the 2 approaches?I understand that this is done well (simply) in the 65...

Application Networking

Forum Posts

Cisco CSS flow idle timeout not working as expected ?

ACE and the app_offline.htm ASP File

Resolved! ACE - peer probes

Resolved! loadbalance for servers thats belongs from different Vlan

alarms on WAE 512

ACE http https rewrite/redirect on same port

Virtual Server on Wave Device

Resolved! ACE FT GROUP.

Reuse of context in ACE module

CISCO WAVE 274- K9 INTERFACES IN BY PASS MODE

ACE 4710 deny SYN-ACK routing without SYN before?

ACE: probe timers

Cisco ACE and IIS Virtual Directories

ACE 4710 problem from server vlan

PBR in ACE4710 or in a 6500?

Announcing Resources That Guide You to Success

Renew.cisco.com just got refreshed, and it will make your life easier!

Community Helping Community: SOS Children's Villages and Nova Ukraine

WAE choses wrong loopback when building its IGP.

software-defined networks and software-defined data centers

Sustainability Survey - Survey Close

Is it good idea to use Common Tenant for L3 Out ?

ACI - L3Out Leaf directly connected network

SDN via API

Cisco data center courses

Hi everyone. I'm trying to use SSH for router and switch

DNAC API call (version 2.2.2.5) - add edge device to fabric

update DNAC