Application Networking

hi allI wanted to please ask about moving rservers from serverfarm1  -to-  serverfarm2Can anyone please list out the order in steps to complete this trivial task?I'm asking since it was suggested to me to remove the entire VIP and all associated conf...

Hi,The ACE primary of platform tv-cat (6509 + ACE20) failed to give service and failed to see the secondary and the opposite too, getting the two active.10134123245 syslog 02/09/2012 14:05:42 09/02/2012 14:05:42 1 Feb 9 Feb 2012 13:42:55 tv-cat-ctxdn...

Hi all,after a long time i have a new issue in our WAAS environment.We're running several WAAS Express devices.And a few weeks ago i integrated them into our WAAS Central Manager.The registration of WAAS Express device was done on basis of "waasx_dep...

Hi,I have a CSS 11503 with a basic content rule for TCP 10000 going to a few backend servers. I was looking into the default timeout values for flows and when testing using telnet the flow didn't terminate as expected?For example, i have no 'timeout ...

We are using the app_offline.htm file to take servers down for maintainence.  I know we can manually take the RSERVER out of service, but the actuall objective is to keep the server up, and let the ASP page return the message to user.  So the app_off...

Hello,Just got few alarms in one of WAE's saying router unreachable.I put the right wccp passwords, reset the cms tables and database, bounced the device but still no good. It can register with the CM but there is no traffic going through.Major Alarm...

I am trying to do the following:http://test.foo.com:8000 -> https://test.foo.com:8000I am able to get redirection to work if the ports are different.  For example, I am able to get http://test.foo.com:8000 to redirect to https://test.foo.com:8010.  T...

I have started leaning on the virtual blade in the wave device, and have run out of space.  I looked at the virtual server and it was setup with only a 30 gb hard drive.  How do I find out what the actual disk space is on the wave device?  Also if it...

Hi all, just have a question about som reuse of resources in a ACE module context.  I don't want to make a new context, and can reuse most of the existing configuration in one of my context.  The config is not complex and difficult, but I'm not sure ...

Dear All,kindly proffer solution. My Cisco WAVE 274-K9 DEVICE WAN AND LAN interfaces are in by pass mode what should i do to get this device up and running ?Jude

Hi there,I've one behaviour on ace, than I can not understand...We've one interface on the ACE which is connected to a firewall via switch.In the same vlan is a serverfarm.net e.g. 172.16.10.0/24the server's gateway is the ACE (172.16.10.1)the ACE's ...

Hi,I've general question about ACE probe timers. I've following probe setup:probe https probe:1061  port 1061  interval 34  passdetect interval 17  open 1 ACE# sh probe probe:1061detail probe       : probe:1061 type        : HTTPS state       : ACTIV...