Application Networking

Hello, I want to ask about the CM hardware requirements. I have a lot of WAVE devices ranging from old WAE 674 to new 294s and 594s. I have to replace the CM which is EoS (WAE 512) with a new WAVE device. Can i buy a WAVE 294 and use it as CM in such...

Stackble -yes atleast 24 fiber interfaces and 40 Gbps copper interfaces 4 Switching  fabric 1.2 Tbps forwarding Throughput 900mpps Min 32k mac entries 

Hi, I have set up a Cisco CSR1000v router in the Azure cloud in West Europe with DMVPN. Everything is working but I'v tried to install a few demo licenses with more throughput but it seems it only allows 100kbps bandwith. First I tried th ax_2500M, t...

Hi All,  Currently we have a setup without VPC that two F5 LTM NLBs are connected to sw 1 and sw 2 with two different physical ports (NOT as a port channels, two links has two diff functions). We would like to utilise VPC feature and we would like to...

I have run src NAT from one VLAN to other VLAN on the ACE OK for years. Now I need to ensure the outbound flow (to internet destination) from two servers is src natted. The inbound LB flow to the VIP (of the two servers) 10.100.60.10 tcp/25 is fine. ...

Peace, here is the message: 2017 Jun 7 17:21:01 Pri-DC-Core-2 %FWM-2-STM_LOOP_DETECT: Loops detected in the network for mac fc15.b422.8ff0 among ports Eth103/1/11 and Po23 vlan 312 - Disabling dynamic learn notifications for 180 seconds Pri-DC-Core-2...

I have major alarms on WAVE-274 (Edge-WAAS) and WAVE-7341(Core-WAAS).Alarm Name: Core_dumpAlarm informations: "User space core files were detected"Is it possible to learn more about this - what caused it, ...ectAny ideas on how to proceed?

Hi Cisco Team,       how many extend SSD  in  C240 M4 SX ? Thank . Best Regards, Kyaw Lin Tun +959795858265

Hi, We have performed the activity by connecting the one port from our nexus to juniper port. After connecting with the juniper the port goes into the down state. And it shows us the reason for done is UDLD TX RX Loop. When i saw the logs on the nexu...

can vxlan be implemented with OSPF as underlying protocol or does it need MP-BGP EVPN? what's advantage of vxlan vs vpls or any other L-2 technologies for Data Center interconnect?

Guys   I have a question RE connecting a VXLAN fabric running eVPN to classical ethernet switches. I have my fabric mapping  vlan 123 to a vxlan - VTEPs are hosted on the 9ks – it is a network overlay only. Hardware Nexus 93180   software - 7.0(3)I4(...

Hi, We have procured ISR 4331/k9 unfortunately we have missed to upgrade the Flash memory to 16 GB while ordering however we have upgraded the hard disk to 200 GB. Earlier we thought of configuring ISR-WAAS 750 however as currently we have only 8 GB ...

Hello Folks, Looking for some feedback on throughput sizing on the ISR 4K routers running ISR-WAAS. http://www.cisco.com/c/en/us/products/collateral/routers/3900-series-integrated-services-routers-isr/guide_c07-726864.html This links shows the follow...