Application Networking

Hi Putting this on the side of the building, what would be the range of access out in the parking lot.  Approxily how many feet with clear line of sight. Thanks

Hi, I have a working setup using ACE 4710 where client connections to a VIP located in client VLAN (VLAN 921) are successfully load-balancing to servers in a back-end VLAN (VLAN 804). I have a requirement for server-initiated connections in server VL...

Hi Netpros, We have been doing a POC with one of our healthcare customers who are using radiation imaging using DICOM/PACS standards. We are evaluating benefits of WAAS with respect to this specific application. Expectations from the customer are two...

My device : Nexus5672UP , version 7.1(0)N1(1b) The mac table are No G flag: F3-N04-SW02# show mac address-table vlan 10Legend: * - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MAC age - seconds since last seen,+ - primary entry usi...

I am beginning to think that my company is the only company who is using RISE with the Citrix Netscalers.... hoping that someone here might have some experience or insight on how this is supposed to work. Long story short we have a pair of Netscaler ...

Hello, Can I upgrade directly from A4(2.3) to A5(3.3) or A5(3.5) ? I read to cisco relase note that :From  Software Version A5(3.1b) ACE will no longer support SSLv3 version of SSL. ACE will support the following SSL versions TLS1.0, TLS1.1, and TL...

Hi, Can we use SFP-H10GB-CU3M instead ofSFP-10G-AOC3M For C2960X-48TD-L  & C2960X-48FPD-L Thanks  Rakesh S 9773452773

Hi all, We have and old DC with two Cisco WAAS's in WCCP GRE mode.This two are working fine, without any problem, see below configuration. wccp router-list 8 10.111.12.129 10.111.12.131wccp tcp-promiscuous service-pair 61 62 mask src-ip-mask 0x1 dst...

Hi,I have outputs from 2 WAE-512s, 1st one is showing all the partitions and the second doesn't match the 1st one. Which command do I run on the 2nd WAE to recreate all the partitions? Is there a performance issue with the 2nd one because I don't see...

Hi All, We are trying to installing Wass-accelerator 4.4.3.bin file on WAE SM-SRE-710-K9 module from FTP server but we are unable to install and got some error. Router1#service-module sm1/0 install url ftp://user:password@10.22.1.132/D:/Ankit/WAAS...

We are working in a project to migrate from Cisco ACE to a new platform. We need to export certificates and keys from the Cisco ACE. We have issues with some keys, as they can only be exported encrypted and we cannot recover all passwords. All privat...

When Cisco Finesse agents (https based contact center) are nearing "tolerable" latency despite having adequate WAN bandwidth, if Cisco WAAS was deployed at both the data center with UCCX (contact center server) and at the agent branch location, would...

Hi –   I am trying to integrate a Cisco Switch IE-3000-8TC-E into Rockwell RSLogix5000 software, so that the software can detect any diagnostic alarms coming from the switch, and publish them on SCADA and HMI.   I read an article on the following lin...

Hi All, I need to replace a Cisco ACE module next week. I have a query about the replacement process. After I remove the running Active ACE module, the fail-over should happen and the standby ACE will transition of active state. When I configure t...