Application Networking

Hi,Is there a recommended standard for http health probes in terms of interval and passdetect interval timings, i.e. should the passdetect interval always be less than the interval or visa versa? Can a http probe be 'mis-configured', i.e. return a 'f...

The customer uses CSS for the load-balancing of Radius servers. He has the following configuration on the CSS:service acs  ip address 10.0.252.1  active owner vzp.cz  content acs    vip address 10.1.48.100    add service acs    balance srcip    advan...

I have a network with 6509 which contains ACE and FWSM.Now Iam planning to use a GSS(4492R) for load balancing between two lacations,but Iam bit doubtfull about the postioning of the devices in the network.So if somebody can help me,pls give a reply ...

Hello everyone,I would like to find out if there is a graceful way of removing a VIP from the ACE Load-balancer config. I attempted to remove it from the service-policy applied on the vlan interface, and I was not able to stop the continious ping to ...

Hi …I configured two Cisco load balancers (two ACE 4710 in active/standby HAV mode), to balance web requests on port 80 among two AS-10g Oracle application servers (OC4J).I am getting the following error when I try to access OC4J forms though Cisco A...

Hello.I'm setting ACE4710.I'm using DSR (Direct server return).The load balancing cannot be distributed now. I append the network configuration. Could someone please help out?THANKS!

What is the Central Manager License used for ?I have 6 Sites. 1 DataCenter 1 DR Site and 4 Branches. At Datacenter and DR Site we have WAE-674 and at Branches we have NME-302 and NME-502.If I purchase Enterprise License for all products do we still n...

I've got 2 servers in a server farm on round robin load balancing set up. Right now, it load balances requests to www.abc.com. I would like all requests for www.abc.com/admin to go to server A all the time. What's the best way of accomplishing this? ...

Hi All,I have the following issue with an ACE Module configured for source-destination IP stickyness ("both" keyword).The client is accessing a web service through a configured VIP.  No proxy is used so each individual client IP address is used to es...

I have a ACE 4710 which I have enabled compression on the L7 policy map using compress default-method gzip. We have recently run a performance test and I have noticed many compression errors on the show service-policy detail output. However I cannot ...

HelloI am attaching a script of a CSS 11503 with four services configured and one content either.  So, i am actually having problems with this configuration, because when all the services are active, it works perfect, however when one service goes do...

Hi,One of our WAE 274 inlinecard is in autosense mode but have diffrent speed on the LAN port "1000" and the WAN port "100", same duplex "full".Is this any issue, as there is no posibility to have diffrent speed and duplex on LAN/WAN?Jan Rockstedt

Hi,A server is responding to PINGs but when configured to be used on the CSS service, it will keep in "Down" state. I have tried to add additional services on the CSS for other valid destinations and all would not become Alive.-----------------------...