Application Networking

I have an LC/APC fiber patch cord infrastructure and I want to connect it to Cisco Catalyst 6500 & Cisco Access 3750 Switches. what type of transceiver should be used?I read a note on Cisco website stating the following for Cisco SFP+ transceivers:No...

We're running ACE SM 5.3(1) and I was wondering if the ACE would allow associating multiple VIPs with the same class-map?Thanks. _ Greg

I'm tired; I hope this makes sense.I have a CSS11503 I'm trying to get set up to load-balance a couple of web servers.At the moment, I don't have the back-end web servers plugged into the CSS directly. They have other L2 devices back there, in betwee...

This may be a dumb question to ask, sorry i don't have equipment to test it at this moment.If wccp redirect is configured on an interface running routing protocol (such as eigrp or ospf), will this redirect the "unicast" ospf database or eigrp topolo...

Hello, I have a Load Balancer (Cisco ACE 4710 with vA4(2)) and two Web servers which is run on port number 443(https) and I would like to get real IP addresses of clients in Apache log files. Unfortunately It seem NATed IP address of Load Balancer. A...

Hi -WAASs and Routers are on same subnet, WCCP L2.Currently, i have dual WAAS using router's hsrp ip address as the default-gateway, everything works ok;R1-physical-ip-address = 20.20.20.2R2-physical-ip-address = 20.20.20.3R1-R2-Hsrp-ip-address = 20....

Hi, We have 3 units WAE294 and 1 for CM another 2 are located on central site and DR site for our V5000 storage data replication..Does WAAS 5.3.1 is support iSCSI traffic? need special setting?Regards,Adam

Dear Sir,We have 2 data centers, and use iSCSI or FCIP protocol as the storage to storage communication protocol between 2 data centers. Due to low bandwidth between 2 data centers, we hope to use WAAS to accelerate ( maybe optimize or compress ) iSC...

Hallo, I use Cisco VPN 3.1.06079. My Computer System is Windows 8.1. Recently after the upgrade of Windows, my VPN always Shows "VPN Reconnecting" and cannot connect with Internet. Sometime the VPN just cannot connect with the Internet. I have reinst...

Hi,Below are default inactivity connection time out for A3(1.0) So by defult any tcp connection(http or https) will be timed out in an hour.The defaults are as follows: •ICMP—2 seconds •TCP—3600 seconds (1 hour) •UDP—120 seconds (2 minutes) as per ht...

I am seeing a strange behaviour in a ACE 4710 (A5(2.1)).I have ssl proxy configured and it mostly works. The only problem is in one provider that  is changing the mss to 536, for this https connection the ACE begins sending data and then just stops. ...

Hello,I have some quick quiets ion with regards to DCI links. If I have L2 between two data centres and want to use MPLS + OTV + MACSec - will that work? I remember there was some limitations where OTV join interface cannot be SVI but must be physica...