Application Networking

We have two CSS devices set up as DNS host for our failover scenario.This works well, but I had a question about the TTL in the config for the DNS a-record.Currently our records are set as follows:dns-record a http://www.mycompany.com 1.2.3.123 50 si...

<p>Hi Guys,</p><p>Simple Q, we have an 1800 used for the WAN router connected to a stack of 3750s. We want to use WCCP for WAN acceleration, but both the ethernet ports on the 1800 are used.</p><p>It  is a routed link NOT .1q from the 3750 to the 180...

Hi allI have an issue with the WAAS reportingI have an application that is running on the port 23, so I edited the TELNET classifier and configured it to perform FULL OPTIMIZATION for all traffic that has a destination port "23".And now in the connec...

Hi, I'd like to place two WAE-612 appliances on both sides of my WAN network to accelerate TCP-based applications, but I'm not sure whether or not I need a WAAS central manager to get these two WAE-612 to work. could someone help to clarify this ques...

Upgrading from 4.0.17b14 to 4.1.1c. Will the DRE cache be preserved or will it need to be wiped and rebuilt as new flows occur?

The ACE active & standby modules are completely in synch, however I cannot ping the peer ip address of the vlan given below. I can't ping the ip address 1.1.1.42 from within the standby ACE module as well. Ping is allowed in the service-policy permit...

Hello,i have a peculiar sitution with my deployment. I am using a 7606 routeras a distribution router. when i do redirection on the tunnel, only one service seems to work. for exam if i redicrect on the wan with wccp service 61 and 62 on the wan, onl...

I would like to have WCCP available on NX-OS to support WAAS DC-to-DC replication or are we saying now that WAAS should not be as close to the SAN as possible and put it out by the DC-to-DC WAN Edge? That doesn't work too well either since I already ...

Hi, This is the current probe that I am using:probe http http-probe interval 3 passdetect interval 3 passdetect count 3 request method head expect status 200 200 Someone told me that I should be using a more sophisticated web page to probe. If you ag...

Hi - anyone know how to configure more than one virtual blade on a WAVE-274?The datasheet at http://www.cisco.com/en/US/prod/collateral/contnetw/ps5680/ps6474/data_sheet_c78-495801.html says that I should be able to configure 2 blades with 0.5G of RA...

Hi,I need to implement HTTP Header Stickiness with this rule:when client send a get to http://vip/?PSONWEBID=12345Server answer at this get withhttp://vip/?SESSION_ID=23123&PSONWEBID=12345I need that ace read 6 character after this string "PSONWEBID=...