Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are currently using WAAS 4.0.17.b.14 to optimize HTTP across the WAN using TFO, DRE and LZ Compression. Does this same WAAS version (or a newer one) support all methods of optimization for HTTPS too?
I'm planning to route some traffic while loadbalancing other traffic.For guidance, what can I refer for simple routing in ACE.In addition, both routing and loadbalancing traffics need to pass a same Vlan in the ACE.In the attached Steps 1,2,3 doing l...
Hi All,We have 2 ACE's in two different 6513 chassis.We are trying to configure redundancy on the, but one thinkit not clear to me. Shouls ft peer X be different on secondACE blade? It's really not clear to me and cisco documentationmakes it even wor...
Hello,I have been asked to configure an ACE-4710, but I have not had any previous experience with these types of devices. I want to implement a fairly simply configuration, but the documentation seems a little confusing - I am hoping someone can ple...
I was reading one of the latest ppt from Cisco Live 2008 on WAAS deployment and it mentions not deploying the Central Manager on the same subnet as the accelerators. I have done this in the past without issue. What is the reasoning behind this recomm...
I was wondering if anyone knew if the new WAAS software version 4.1 gets rid of the idea of connectivity groups and having to identify a WAE as a core, or edge rather than it operating as either without extra confgiuration? I have tried looking in th...
if i have waas mobile software installed on client pc, which goes to a modem using NAT, will waas work with applications like ftp which may send NAT info in the payload. Also, i wanted to know if WAAS can optimize GTP traffic.
I am having troubles with a HTTP return code probe I am trying to create. (see config below). I have a vserver built that allows connections to any TCP port, I cannot get a HTTP return code probe to work.I have tried the following three scenerios:1....
I have four switches, 2 cisco 2960 and 2 dell powerconnect 5324 that are redundant to each other. All switches have a physical connection to each other. Currently when one switch goes down I have to manually failover to the second switch. Can I do a ...
Hello,I wonder if it's possible to do redirects by url rewriting. In fact, I want to redirect all HTTP requests to a single designated page. I dont want HTTP-302. I want CSS to do the rewrite job. Is this possible ?I was pretty sure it was but cant f...
The system is one Core and two Edge devices, plus the CM. The core is a WAE-512 and the edge devices are NME-WAEs, all running 4.0.19.14. WCCP v2 being used for redirection.Core and Edge file services are enabled and running in transparent mode with ...
I'm looking for a data center caching solution. I can only find performance comparison of C3845 router with small numberof sessions (5 only). CPU usage will be increased by 50% when WCCP is turnedon.Does anyone know the performance figure of 7200+NPE...
I have an 11503 and I am trying to load balance sftp servers behind it. not sure why it's not working. here is the content rule:content test_sftp add service www1_sftp add service www2_sftp port 22 protocol tcp balance aca advance...
