Application Networking

Hi allI have a question regarding QoS and WAAS. From documentation I've ascertained that QoS needs to be done on the routers. Configuring a service policy on the output interface can be used to guarantee bandwidth for certain applications. However, t...

I am trying to spec up a kit list for 6509 ACE bundle. The options are confusing - any help ?

Greeting,Could a simple sorry page be hosted on either CSS11506 or GSS4492R?If so, please give me a clue?Any comments will be apprecitedThanks in advance

we have configured a serverfarm with some real servers.snmptrap/syslog is configured to message in case of a status change of a real server.Some messages have been configured to a lower level of alerting : logging message 442001 level 3logging messag...

Hi everyone,I have encountered the symptom that CPU utilization on CSS 11501 is increasing periodically.I assume that this symptom is caused by handling many traffic on CSS 11501 and I am thinking it would be better to replace CSS 11501 to CSS 11503 ...

We are Encrypting a particular element in the Oracle SOA suite and decrypting the value in XML Gateway side, but always we are getting the following error in the Gateway, Can you please help me on this.Error Message:Error decrypting message: No key m...

Hi,We have need to redirect subdomains through the CSM to various parts of our normal production website. For example, we want to be able to go to "http://whatwedo.company.com" and then we want to automatically redirect them to "http://www.company.co...

Hello, I'm trying to nat server initiated flows toward the outside world on the same address as a VIP used for other purpose.The ACE does not accept that config line and says something about the object being used elsewhere.Do you think it's possible ...

hello,can me anybody tell, how is limited CSM throughput using predictor forward? in other words I have two interfaces/vrfs on the cat6k and these networks are routed through CSM (some traffic is load balanced on the CSM) and my question is, if it's ...

SW 3.0(0)A1(4)I've configured SSL initiation and noticed that a successful session is established despite no valid root CA cert installed on the ACE.Does client SSL just work regardless without any cert validation?

hi ,i have a problem in csm-s, i config a csm-s mdule in a 6513 chassis and it was working correctly but in this week i receive following error message, 11/7/2007 8:08:08 AM agg1 1231: Card in module 3, is being power-cycled off (Module not respondin...

Hello, I'm trying to locate version 6.x of the software for the Cisco AVS 3120. I heard version 6.x was removed from distribution due to code problems? Is this true?

Hi,What is the timer in the sticky group do? It is an idle timer or cache timer? I am using source ip based sticky on one of my vserver. there are two reals behind it and only two front end (proxy) web servers that hits it. when I remove one of the r...