Hello;Is there a way to insert date and time into http request like:http://myserver.lan:2719/201312100806or something like that.I have tried with action-list + uri rewrite + some % variations but without success.Thanks for answer.Branko
Hi Team, We are facing issue with WAAS device " WAAS is showing offline in CENTRAL MANAGER ". Troubleshooting Done:1) Login into the WAAS appliance (10.2.58.55) => Able to telnet 2) Check the WAAS can ping the Central Manager IP address (10.240.15.50...
Hi Community,we have a new requirement to enable a connection to a server with SMPP protocol wrapped inside a SSL channel for transport over internet. Can any one suggest if the ACE module support to do SSL initiation to secure standard SMPP (3.4) se...
Hi all,I am using a Cisco 3825 running 12.4(25G) code. I just upgraded my WAE (oe674) to 5.1.1c.The WAE and router wouldnt peer due to assignment method mismatch when i do a show wccp router.Router Information for Service Id: 61 Routers Seeing...
Experts,My Customer is working on optimizing the environmental conditions at all his Data Center locations (Currently they are in the range 68F to 74F at their locations and they want to increase the temp to 76F) . So, the customer wants to know the ...
Hi,Just after clarification on how the failover process works,and whether the would be any problems expected if we have a primary CM in Australia, and the standby in California?the documentation is a bit light on how this actually works, but my under...
I am not getting special characters in accepted in http health probe in cisco ACE . i am not getting any error but its not accepting it .. is there any way to configure it . /search?proxystylesheet=heartbeat <i want to use >/searchproxystylesheet=hea...
Good morning to all.I'm enabling a syncookie protection on a Cisco ACE 30 Load Balancer.I set the value to XX = sum( synbacklog queues of 4 webservers ) * 0.7 so we have the theshold set to 70% of total syn manageable by all webserversI understood th...
ACE model:ACE-4710-K9In ACE load balance we are facing kerberos authentication issue. When we are accessing a server directly (10.1.8.62) its working fine, But when we are accessing with LB vip address (10.1.4.33) its asking authentication.How we can...
Migrating from a single 4710 appliance to a pair of ACE30s in a VSS cluster. The 4710 is running in bridged mode and I plan on utilizing the same VLANs and mode for the ACE30s. They are currently configured as a redundant pair. I have not yet turn...
Hi allCan see that for a particular context, probes attached to a serverfarm are being sent from both the active & the standby ACE modules.I had the presumption that only the active module would be sending probes.Are probes being sent from both modul...
All,Can anyone explain how WAVEs (caches in WCCP lexicon) are assigned to buckets please?The context to my question is probably best illustrated by an example:* You have two CEs (CE-A and CE-B), each with a provider circuit* Asymmetric routing across...
I configured TACACS+ and logged in with an account before creating the account and assigning it a role in the WAAS CM. I then figured out that I needed to create the account and assign it a role before I could actually do anything with the account. ...
