Application Networking

Hello,i have a question about the keepalive and Service state.There is a keepalive frequency which is the time between normal keepalives are sent, when the service is alive.So my question goes specialy to the retry-period.If the keepalive response to...

I have been told that a CSM by default has all VLANs on the Cat 6500 trunked on its connection to the backplane and the catalyst autostate feature does not work in this case as you cannot remove the VLAN from the trunk. To explain it a little better ...

First, here is a diagram of my setup:CSM w/VIP for Front-End Web Servers (acting as Authorization and Reverse Proxy)|SSL Module for termination of HTTPS traffic|Front-End Web Servers|CSM w/VIP for Back-end Web Servers|Back-end Web ServersWhat I need ...

I have a Netcache configured for transparent caching for port 80 and 443. The Netcahce IP is 164.72.49.253. We have a 6509, sup720 IOS. 12.2(17a)SX3, configured to redirect web-cache and 1 to the Netcache. Here is the config:ip wccp web-cacheip wccp ...

I have recently tried to install a 2950 48 port catalyst into my network and my LocalDirector 416 does not want to negotiate with it. IT has no problem with a 3524 Catalyst, but the interfaces connected to the 2950 remain in the (waiting) state. I am...

When a service (TCP) is down, the client requesting via VIP does not detect the service is down on the server till abt 25 sec later.If bypassing the CSS, the client requesting the service directly on the server detect the service is down almost immed...

A Cisco CSS 11052 ids was picking up ping sweeps and we realized the load balancer was doing it. It was sweeping for 10.16.x.x subnet. I need to know why it's doing this and if there is a way to and turn it off.Thanks for information you may have.

I only found the documentation for critical services "scripted, redundancy uplink and local" in the advanced admin guide Rel 7.2--snip-->scripted - the priority changes to 0 when one service in the scripted group goes down. redundancy uplink - the pr...

Hi All, I tried to force the TTL of cached objects ussing rule and templates on a CE-565 but the object remain cached enven after the ttl expiration; here is the configuration:http cache-cookieshttp cache-on-abort enablehttp proxy incoming 80 http ma...

Hi,my question:Is it possible to set up two 3550 with HSRP, and to have the HSRP logical address to be the one ip address to communicate to a WCCP cache cluster ?(I'm aware of this: "This software release supports the connection of only one 3550 swit...

Hello all I am new to the 11503 switches and would appreciate some help with the config. We are replacing our LD417G's with these switches and because of our current DMZ setup & ip addressing i cannot setup the 11503's in router mode. What i have don...

Hi,My CSS 11501 is connected to 2 Server using port 1 and port 2, the 3 port connected to the firewall.I've keep getting as below on my log:JUN 12 01:38:24 1/1 130 NETMAN-2: Enterprise:Service Transition:Server2-80 -> downJUN 12 01:47:59 1/1 131 NETM...

standby CSM go hanging. without log message.and no output for CSM command that "show mod csm 9 vser, show mod csm 9 real" and can't connect vserver on this CSM...