Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am facing the follwoing problem,we have configured a cisco ace 4710 with VIP to load balance between two servers,this cisco ace is placed behind a cisco asa firewall ( with failover ) and the firewall is passthrough ( passing all traffic),whe...
Hello Everyone,I intend to Configure two ACE appliance in one arm mode, Post configuration I have tried to test the functionalities of the same.Below are the queries which I am having now.>Post reboot of the appliance it popped with the error ,pls cl...
Hi expertsI have some questions about ace's behavier.1st one is, Does ACE send a RST packet when it reach to inactivity timeout?2nd, Does half-closed timeout works properly with "no normalization"?3rd, How does ACE treat the packets there is no flows...
Hi In my setup , I have 6500 with FWSM and ACE module . FWSM is configured in trasparent mode , multipl context . ACE is not yet configured .I have a requirement to configure the ACE to load balance exchage servers traffic.Exchange...
Hi Experts,My question is one of my ACE module running A2(1.6a) have been crashed due to SRAM parity error.ACE20Admin#show versionSoftware Version A2(1.6a)last boot reason: NP 1 Failed : SRAM Parity Error Chan 2I would like to know is this a Softwa...
Hi.Two service group identifiers are required for WCCP redirection for TCP and second one is automatically set for UDP even if it is explicity specified?.for example:ip wccp 41 redirect-list ....ip wccp 42 redirect-list ..Is my understanding correct ...
Hi,Experiencing slow performance for http utilizing waas.When looking at the statistics, I see that some http request which is optimized/accelerated. Other is not. Those that has no optimization/accleration, the optimized traffic is higher than the o...
Hi all,i have a two-arm loadbalancer (routed mode). client ->vlan100->[VIP]Loadbalancer[NAT] ->vlan200-> serverfarmBut i have my problems to configure the NAT. Can anybody show me a example configuration of a two-arm loadbalancer with NAT?Especially ...
Hi,I have a couple of devices which aren't supported under a SmartCare or SmartNet contract and their disks have failed. On speaking to Cisco I have discovered that the replacement disks are no longer being sold for WAE-674-K9 and WAVE-574-K9 so we ...
Hi thereI'm Kilsoo.I made One-armed mode using ACE.Real servers are in away Vlan from ACE.So, I configured the PBR with ACE alias ip address for the next-hop on the real server's gateway interface.And, the probe from active ACE works well.But, the pr...
Hi allI like to tune the switchover timer for a SorryServer configuration. Actually the timer are set by default to 5 minutes.I like to tune the timer down to 1 minute. Is there a configuration option to change this default timer?Thanks for feedback.
Hi experts,i need your help. I have a two-arm Loadbalancer concept for ldap and ldaps. The LDAP Clients talk to the VIP of the Loadbalancer on port 389 or 636 in the Frontend VLAN of the Loadbalancer. The Loadbalancer distribute the TCP Connection (...
The SNAT rule is configured in ACE 4710 which is currently working fine but the application end user is complaining that they are able to see the ip address of the real server.Vip address - 10.80.74.24Tomcat 1 - 10.80.133.19Tomcat ...
