I have configured a CSS11155 with dns-record command in version 5.02 as a dns server. When I ping a domain address from a client the CSS resolves the name and ping responds as it should. But when I do a nslookup from the same client this fails. Does ...
I am wondering what would be the benefits for going with the Content Switch Module versus and stand alone Content switch? Does the Content Module do more than the Content Switch? And what would be the requirments for using a Content Switch Module i...
We have configured wccp on a 7206 and CE590. The router has cef enabled on it. With cef enabled the cache engine does not work. When cef is disabled the cache engine works correctly. We have tested the same setup with cef and wccp on a 2600 router an...
Hi all, working with ECDN (CE,CDM) running ACNS4.0.1 and trying various configurations for the live streaming, i have the following questions: 1] I have enabled the WMT Server on the two CEs with a license key. I would like to do the same on my CDM, ...
I have got two CCS 111520. One is working, the other is spare, which I want to make it work as warm backup or load balance to the other. Could you please tell me how? Thanks.
CSS11000 was upgraded with new IOS image.However, it did not take the current config (which was 'wr m') when rebooted from the new image. It seemed to have taken the config from another disk partition -?!. We had to revert back to the old boot imag...
Recently installed Cisco CE-505 and the customer wants to direct everything to Microsoft Proxy Server for authentication and URL filtering with SurfControl. I added the command: http proxy outgoing host 192.168.90.2 80 primary - which directs all H...
I have a customer who wants to know if load balancing 2 Checkpoint firewalls can be acheived by using local directors.Would this require a local director inside and outside of both firewalls?How would a conversation that passes through a local direct...
I am trying to set up FTP thru a localdirector and cannot get it to work. If I target the real address, I connect fine. If I target the virtual address, no go. I've tried SERVICE FTP-PROXY to no avail. FTP config is:real 165.215.41.43:21:0:tcp isv...
My webservers hosts multiple sites and naturally I use host header names because I only have ONE ip number. Each website have its webdata located on a NetApp filer on the network. When one website is disabled the corresponding service is still marked...