hi everyone i am setting up a lab on cisco packet tracer to create an access via ssh. I created both a dns server (from which the encryption keys will be generated via ssh), two PCs and a switch in the center. On the switch I configured the vlan 1 (t...
Hi, I'm looking for ECCN, HTS/EU Taric codes for the following products: - CW9172I-CFG - C9300-48UN-E & C9300-48UN-A - C9300-NM-8X - C8200-1N-4T - C9300LM-48UX-4Y-E & C9300LM-48UX-4Y-A Can anyone help me on this?
Good day,I am planning to get rid of the N5K Datacenter Fabricpath to be replaced with Nexus 9K.of course, VPC will be in place for the N9K but what will be the best replacement for the Fabricpath replacement.1- Migrating Cisco FabricPath Environment...
Hi Guys,Wanted to know what was the preferred or Cisco accepted way to install / configure multi-tier certificates on the SSL module? When reading the config guide, it discusses in detail how to handle a single tier cert (i.e just a root ca cert), h...
Hello Expert ,We are replacing the N3K device with N9K .We could see N3K has LAN_BASE_SERVICES_PKG license whereas in new N9K device there is no license ..Will this have any problem after the switch replacement ?N3K : N3K-C3048TP-1GE ...
Hello, We need HTS, Harmonization Code and ECCN for the NCS2006-ECU-S=
Hi, I have a line card (A9K-24X10GE-1G-TR) that has gone down and needs to be replaced. At the moment, there is no service outage. Could you please provide me with the proper procedure to install the replacement part?Will the firmware need to be upda...
Hello,I'm trying to setup a pretty simple solution for web servers load balancing using ITD on Nexus 93108TC-EX with NX-OS 10.3(6)M.There is a Deployment guide for Direct Server Response (ITD Service), and I'm following it with 3 exceptions:Ingress ...
Hi friends, I'm trying to configure the DNA with the Cisco 9300. Please do you have a guide on how to do it, as the configuration doesn't seem very user-friendly. I'll be waiting.
I had a really old DNA sitting on a shelf since before COVID that i just plugged in.I got the CIMC setup and i ran the Maglev Wizard and i do believe it completed (finished after work hours).If i log into the CIMC and Launch the KVM is get a "Welcome...
all the vms on the esx restarted after deployed NDFC . it disables the access to the storage any idea ? ESXi vmware , the hardware is DELL MX 760
Good afternoon,We need HTS, Harmonization Code and ECCN for the following item.Cisco Catalyst 3560-CX 12 Port
Consider that L3Out Link is not yet in Place between PRD Tnt to ISN RTR ( at left side of the Diagram ). I am evaluating the situation if I bring the L3Out Link between DR PRD Tenant to ISN RTR. At DR Site PRD Tnt through L3Out it will receive Route ...
Hello WAAS Experts,Can Cisco WAAS communicate with Juniper WAN Optimizer? If so, which Cisco and Juniper hardware models?Thank You,Audie
Good DayI have a pair of C8200L devices racked and online.These will be running a redundant Call Manager Express install.First I am told I must configure Box-to-Box redundancy.I navigate here but find this document unusable:Home > Support > Product ...
