Cisco Software Discussions

Juniper has a bunch of nice, free guides for folks moving from IOS to Junos. I don't even really need that much - even just a list of the several hundred typical commands and what they might be in IOS would be huge. I'm not having much luck searching...

HiSometime over the last couple of weeks, something has changed either in Airprint on ipads or the way the Meraki MDM global http proxy setting is applied.With a proxy setting pushed out by Meraki as the global http proxy, the ipad cannot connect to ...

Hello All, I have heard that other models capable of SD-WAN (C1K, ISR series, etc.) have a different license concept because they are H/W-based, unlike the 8K series.However, I understand that now C1K and ISR series also need to purchase a DNA Licens...

Hardware type: ExaNIC X25Serial number: FOC26513XJ7Issue: Upon SFP/QSFP module insertion, the port LEDs  turn orange. Then I check "exanic-config",  the port is signal detected but no link and disabled: Port status: disabled, SFP present, signal dete...

I have Cisco switch - WS-C3750G-48TS-S, I bought it refurbished.Currently on the switch I have SW-version firmware version12.2(46)SESW-image C3750-IPSERVICESK9-MIn this case, is it viable and possible to upgrade or rollback to IPBASE version 12.2.55-...

With MAB out of the question, how do organization manage 802.1x network access for Cisco Webex Room endpoint devices without any possibility to push certificates directly from WebexHub. Do you use thirdparty tools or do it manually?

Hello, We having a problem with  Nexus 93240YC-FX2 Switch, currently it is using Os version 14.2.7s. I want to upgrade it to version 16.0(3e). I followed the instructions as follows:loader > dir usb1:usb1:aci-n9000-dk9.16.0.3e.binloader > boot usb1:a...

Hello Experts,APIC displaying the fault F0103. I searched some community discussion about this which determine that it's a bug CSCuv63617.Bug Link: https://quickview.cloudapps.cisco.com/quickview/bug/CSCuv63617. How can we mitigate this bug without d...

Is there any difference between a single node DNAC vs a three node cluster DNAC ?I am already aware that HA(high availability ) needs a three node cluster . Other than that what else can I find different. ?

Hi,Am I able to copy the config from a IOS XE Everest 16.06.02 to Amsterdam 17.3?Will there be any issues or errors?Thanks

Hello! I have several Aironet boxes (AIR-AP1832i-B-K9), most of them have absolutely no problems but two have spontaneously stopped receiving power. We've checked the breakers, and the routers, and tested the cables all of which are functional. Is th...

After quite a lot of troubleshooting I found that the latest IOSvL2 image fails(throws CPUException and resets) when I bring up L3 port-channels with multiple subinterfaces. Where can I report bugs like this?

Is there any Cisco documentation explaining how to update the java version by itself on the existing 12.5 version of ECE

We're utilizing Cisco ISE for 802.1X / MAB authentication and dynamic VLAN assignment. In our environment, there is a large bunch of medical modalities that require networking to communicate with their backend servers and systems. The challenge is; a...