cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1222
Views
6
Helpful
2
Replies

Agent state stays READY when using their direct primary extension

joerunning
Beginner
Beginner

Finesse agents in READY mode are complaining that when they answer or originate a call on their direct Primary Extension that they are not automatically placed into NOT READY mode. When the agent places an outbound call on their Agent Extension, it does automatically go into NOT READY - OFFHOOK mode. These agents are using NOT READY reason codes.

 

Call Manager System version: 10.5.2.13900-12

UCCX System version: 11.6.2.10000-38

 

1 Accepted Solution

Accepted Solutions

Hey joerunning

 

This it what the documentation says :

When an agent is busy on the secondary Non-ACD line, the agent state is changed to Not Ready if it is configured by Administrator. Agent can also make a call from the Ready state.

 

This is a setting under the "system -> system parameters" (default is disabled)

AgentState.PNG

 

Best regards 

Thomas

Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Thomas G. J.

View solution in original post

2 Replies 2

Hey joerunning

 

This it what the documentation says :

When an agent is busy on the secondary Non-ACD line, the agent state is changed to Not Ready if it is configured by Administrator. Agent can also make a call from the Ready state.

 

This is a setting under the "system -> system parameters" (default is disabled)

AgentState.PNG

 

Best regards 

Thomas

Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Thomas G. J.

Thank you very much! The solution you found does appear to be the case. I will make that change and perform testing.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: