09-14-2006 10:35 AM - edited 03-14-2019 12:05 AM
Good day.
I try to install IPCC Enterprice 7.0 and faced with the following problem.
LoggerA and RouterA been installed on Rogger1 and LoggerB and RouterB been installed on Rogger2.
LoggerA and LoggerB databases have been created.
The problem is:
If RouterA is out of service (I stop the service or Rogger1 is out of network) then RouterB service restarts and after restart it does not work.
I tried to:
synchronize Logger SideA and Side B databases
recreate both databases
ICM7.0.0_SR4 was installed and it did not help.
full reinstall did not help.
Servers that are used:
MCS-7835-H1
Switch:
Catalyst 3750 48 10/100 PoE + 4 SFP Standard Image
OS:
MS Windows 2003 Server SP1 Standart Edition
MS SQL 2000 SP4 Standart Edition.
Could you give an advance of problem solution?
Thank you.
09-14-2006 06:16 PM
Can you give more detail on how router B doesn't work?
Normally you shall start first logger, then first router, second router, second logger. You should also need to check IP connectivity and host name resolution for all nodes.
Wei
09-15-2006 12:06 AM
Hi,
Try to check in the Logger set up if you have selected 'duplexed' and check the Rogger ip addresses in the set up.
Try to provide more information regarding your installation.
Hope this helps,
Juan Luis
09-25-2006 11:22 PM
Do you have any PG's configured? RouterB needs to see majority of PG's if it cannot contact RouterA.
If this is a lab configure a dummy pg (no need to enable PIM) on your Roggers and you should be fine.
09-26-2006 09:20 AM
post up the logger B dumplog, that will help us.
Also try to ping both private and public connections using both the ip address and the hostname.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide