05-14-2014 05:34 AM - edited 03-15-2019 06:00 AM
Hi,
We have recently done installation of UCCX 8.5 and CUCM. Contact center agents run in multiple shifts and the same places are being shared by agents depending on the shift timing. Now, in order to acheive this, we are using Extension mobility with CAD. Here agent has 3 steps to follow:
1. Login to phone with ExMobility
2. Loginn to CAD on the PC
3. Press the 'Ready' button in CAD to start receivng calls.
These sounds too much for the non tech savvy agents. In other systems like Avaya, there is single sign-on available where they just enter extension number and get logged in from any desk.
Is there anyway to achieve this ??? Atleast, can we make agent automatically ready when they logg-in?
Saif
05-14-2014 05:51 AM
It is a lot to ask an Agent to do; however I've found they quickly learn and remember what to do.
That said there are a few products out there that sign the phone in using extension mobility when they log in to their (Windows) computer. There are limitations with these products though (thin clients and VDI's etc) but worth a look.
A couple I've looked at but not tried -
http://www.rsconnect.net/en/solutions/single-sign-on---alm/alm-overview/
https://www.voipintegration.com/Software/Extension-Mobility-Single-Sign-On/
Jeff
05-15-2014 07:35 AM
I agreed with Jeff, it can look like a lot of steps, but at the end is just 2 or 3 logins what they need to make :)
All our agents uses extension mobility + CAD + manual "ready" and it works just fine :)
Regards.
Rolando Valenzuela
05-14-2014 08:17 AM
Hi Saif,
you can make agent automatically ready just after login . You have to create workflow in CDA.
please follow the guide lines of below doc. This doc is for auto logout . just change it logic and it will work for you . I have tested this in my lab .
http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-contact-center-express/112113-cda-logout-00.html
If you want you can configure one button login in IPPA. but customer will lose feature of CAD.
Regards
Ravi
05-14-2014 10:18 PM
Hi Ravi,
Thanks for the advice.
I had tried doing this but could not succeed. For the new work flow (or even the default), the 'events' column shows only "Startup,Shutdown,Ready and Not Ready" states. It does not show me the "Logged In, Logged Out and Time of the Day" events. Im using UCCX 8.5
Any ideas?
Saif
05-17-2014 07:28 AM
Hi Saif,
You have to select not ready . and workflow will make agent automatic ready . because by default
when you login agent will go to not ready state .
Regards
Ravi
05-16-2014 09:23 AM
Do agents move around desk to desk, or are they assigned a specific phone? If they sit at the same phone everyday, you could eliminate the EM portion by assigning both agents to one extension on the same phone or put multiple extensions on each phone, and an agent would use their designated extension.
That being said, I prefer the EM method you described above.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide