10-03-2012 11:55 AM - edited 03-14-2019 10:37 AM
Hello, all. I understand that with desktop recording and server recording you could pass UCCX enterprise data as metadata to QM with IPC integration. However in QM network recording deployment mode is there a way to pass the data to QM?
Thanks.
Solved! Go to Solution.
10-09-2012 05:27 AM
You must send the internal QM user ID in any commands you send to the server. In CCX this is 1.
If you are sending this from CAD you can split this into two fields.
sender_id with the agent ID and peripheral_id with the 1 in.
See this link for some examples. Page 25
Note that the examples are from an Enterprise system so the peripheral_id is 5000, replace this with 1 for CCX.
You should also be aware you must send fields in the command in the correct order.
You should send the UDP packet to the QM server that is doing the recording. That's the one at the end of the SIP trunk this agents is pointing to.
Please rate helpful posts.
Graham
10-03-2012 11:47 PM
If you're using server recording or network recording you should use the method described on page 25 of this document:
Brian
please rate helpful posts
10-04-2012 07:50 AM
Thanks, Brian. However can you let me know in a network recording mode what's the recording server that needs to be put in CAD workflow? In device management in QM admin, I thought recording server field will be blank? Or we just put the QM server IP there in the CAD workflow? What will be the port value?
The CAD integration guide only mentioned server recording and not network recording. However from your response I assume it worked the same way?
10-05-2012 02:02 AM
Yes, in my experience the work the same way. You leave the recording server field blank in QM admin for network recording. In the CAD workflow, use the ip address of the QM server the agent is set up to use. You use the same port number.
Brian
10-05-2012 01:57 PM
Thanks. I believe you're right.
However I configured it in our lab, the recording server got the IPC message correctly but got the following error:
processMessage: API message was not handled due to unknown sender.
I've configured sender_id with value of 'agent_ID' but I'm not sure why I got above error. I'm passing the correct agent name, and in QM it's integrated with UCCX so it's the same. Only thing is that the QM user_ID has '1.' as prefix, and that I'm not login windows as the 'windows user name' configured in QM admin user. I wonder if that'll cause this error?
10-09-2012 05:27 AM
You must send the internal QM user ID in any commands you send to the server. In CCX this is 1.
If you are sending this from CAD you can split this into two fields.
sender_id with the agent ID and peripheral_id with the 1 in.
See this link for some examples. Page 25
Note that the examples are from an Enterprise system so the peripheral_id is 5000, replace this with 1 for CCX.
You should also be aware you must send fields in the command in the correct order.
You should send the UDP packet to the QM server that is doing the recording. That's the one at the end of the SIP trunk this agents is pointing to.
Please rate helpful posts.
Graham
10-14-2012 05:41 AM
Thanks. It worked now in our lab after I added peripheral ID in the right order. Yes I didn't follow the exact order at beginning and that has caused the error message in the log.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide