04-18-2018 11:17 PM - edited 03-17-2019 12:39 PM
Hi,
We are trying to setup an 8865 phone with 8865 KEM (dual screen, 14 buttons, 2 pages), however, the module does not seem to be coming up. At one stage, we received an alert stating "Accessory Added: The phone is not setup for the expansion module" however, there seems to be no backlight or any activity on the expansion module.
Phone has been setup with KEM and phone button template (10 lines + 28 BLF) in CUCM, running 12.0.1-SR1 firmware on CUCM 10.5.2. Switch is 2960X and hence is capable of 802.3at (PoE+).
Total drawn Inline power on port is 14.7 watts irrespective of having KEM connected to phone.
Is there anything else I could check? Is there anyway to check whether expansion module is receiving power? I'd assume it receives power from side USB port on phone which, by the way, is also enabled on CUCM under product specific configuration.
Any help will be appreciated.
Thanks.
08-09-2018 01:16 AM
08-09-2018 02:30 AM
08-15-2018 06:03 AM
I am running into the same issues and all others.
I have the latest CUCM version 12.0.1
Latest 8865 firmware 12.1
I have tried anything but i get the error that the phone is not set up for the expansion module.
What else is needed to get this working?!
best regards
Jón Ragnar
09-13-2018 05:08 AM
Hi All,
This is related to the same problem where we're trying to add expansion module CP-8800-A-KEM= 28 Button with Cisco 8861 and getting error on the phone "Disabled by Admin".
Where as 36 Button Module is working fine with the same phone.
Any Suggestions?
Thanks
10-20-2018 02:38 PM
I found I had to set "One Column Display for KEM*" to ENABLED to get the CP-8800-A-KEM to work with the 8851 in CUCM 10.5.2. The new 28 button phone models are designed for single column display. I bet the same is required for the V model. The setting is at the bottom of the Product Specific Configuration Layout
04-08-2019 07:23 PM
Does anyone know if the 8800 VKEM is compatible with the 8865-3PCC? My sidecar isn't powering up either.
04-09-2019 09:02 AM
Is all config set properly? Was the KEM type set on ATT console page?
A separate topic would be preferred for MPP issues.
04-09-2019 10:01 AM
02-10-2020 07:12 AM
Hello! I have same problem with 8861(sip88xx.12-0-1-11), 8800-A-KEM and CME 12.0 ((C2900-UNIVERSALK9-M), Version 15.7(3)M5, RELEASE SOFTWARE (fc1))
Is existing some way for fix the problem?
Thanks in advance!
02-10-2020 08:02 AM
07-05-2022 07:27 AM
I had the same issue when I replaced a damaged 8851 IP-Phone, I solved the issue changing the phone button template to a generic 8851 phone button template, cause I've made a device copy from the damaged, and it had its own MAC-phone button template. After that change and a phone reset, the KEM turned on, and able to configure the speed dials.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide