cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
943
Views
0
Helpful
6
Replies

CUCM T1 CAS into an Adtran

CARLO CALABRESE
Beginner
Beginner

I have CUCM 7.1.5 and i have an adtran 850. i have connected the 850 via T1 CAS connection to a 2811 running mgcp.

I get calls inbound and out just fine. The only problem i have is that the calls show a call ID of unknown.

Is there a way to add an extention number to the port?

1 ACCEPTED SOLUTION

Accepted Solutions

linuxchild
Beginner
Beginner

Hi

are these checked under the port

View solution in original post

6 REPLIES 6

linuxchild
Beginner
Beginner

Hi

are these checked under the port

Thats on a PRI connection, this is a CAS so the ports are EandM

T1 CAS does not support outbound DNIS.

If you want it, and mnay more features, get T1 PRI instead.

Or you can ask telco to display a same number for all the calling extensions.

I was trying to connect this site without upgrading the key system.

Thanks.

Possibly it will be less expensive, and more feature rich, to just install IP phones at the site, and then use the T1 capacity for voice and between offices.

CARLO CALABRESE
Beginner
Beginner

I found a way around it. I created a new partition and calling search space. I then created a translation pattern of @ and added the calling id for the system in that.

I have 20 sites like this so putting ip phones is not an option and it would cost to much to upgrade the systems to PRI.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: