cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1046
Views
5
Helpful
11
Replies

E164 dialling to internal number

kpintens
Level 1
Level 1

Hi all

is there a way, without using transformation patterns to translate an incoming E.164 number to 4 digit internal number

eg +32 1456 789 3123 to 2501

currently it is working using a transformation pattern on the trunk but using this method as soon as we partition the numbering plan incoming calls fail.  The internal numbers are in <none>

 

Thanks in advance

 

Koen

1 Accepted Solution

Accepted Solutions

Please remove the significant digit and configure xlation pattern to match the full pattern eg

Translation-pattern \+3214567893123

partition : select a partition that your sip trunk CSS has access to

CSS: Select a CSS that has access to the phone DN partition

called party transform mask: 2501

Ensure your sip trunk CSS can access the pt of the xlation pattern

 

Please rate all useful posts

View solution in original post

11 Replies 11

Transformation pattern are used to change the number displayed on the phone once the call arrives.

 

I'm assuming that 2501 is an internal number, you can to this in the gateway or the trunk configuration page.

 

Call Routing Information - Inbound Calls:

thank you

that works but then it doesn't work when adding partitions

 

so in a way the problem lies now with partitions and CSS.... grrr

 

For example:

 

Parition:

PT-Phones

Since the phones are now in a partition the GW cannot reach the phones without a CSS that contains the above PT:

 

CSS:

CSS-Gateway: ---> PT-Phones

 

If you assign this CSS to the GW then calls will work.

en calls will work

 

Call Routing Information - Inbound Calls:

Significant Digits: 4
Calling Search Space: CSS-Gateway

 

this is what I have

PT_site -> phones

PT_system -> route patterns

PT_site_emergency -> specific emergency translation for that site

 

CSS_Site has all three PT's

 

as soon as I assign a phone in the PT_site the incoming calls fails, provider msg that there is no phone allocated

Ok,

 

Are you trying to translate 32 1456 789 3123 to 2501 --> if this is the case use the GW to translate the number to 2501

or

32 1456 789 2501 to 2501 ---> use the CUCM as shown above.

Go the Dialed Number Analyzer in Serviceability page, once there select:

 

Analysis -- > Gateway

Select on the Gateway

Calling Party: (Any number)

Called Party: 32 1456 789 2501

 

Any attached the output

here is the catch..... it is a SIP trunk directly on the CUCM no gateway involved, no CUBE due to budget restrains

This is very straight forward. You should use translation patterns not transformation pattern for this. Configure the pattern and select the CSS_site for the xlation pattern.

Please rate all useful posts

it doesn't work :(

 

trunk significant digits 6

translation pattern 123456 to 2000, PT_site, CSS_site

 

I am sure I am must be overlooking something

Please remove the significant digit and configure xlation pattern to match the full pattern eg

Translation-pattern \+3214567893123

partition : select a partition that your sip trunk CSS has access to

CSS: Select a CSS that has access to the phone DN partition

called party transform mask: 2501

Ensure your sip trunk CSS can access the pt of the xlation pattern

 

Please rate all useful posts

that worked

thank you all for the help

Glad to help. please mark the thread as answered

Please rate all useful posts