Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Is there a reason why there is a difference in the output:
On the active controller:
Show license capacityLicensed Feature Max Count Current Count Remaining Count-------------------------------------------------------------------AP Cou...
Hi allis it possible to configure 2 SIP trunks to the SBC of one SIP provider? The SBC has the same IP address and the only difference between the trunks would be the credentials.On a CUCM I can not add a second user in the same sip realm, so the cu...
Hi allis there a way, without using transformation patterns to translate an incoming E.164 number to 4 digit internal numbereg +32 1456 789 3123 to 2501currently it is working using a transformation pattern on the trunk but using this method as soon ...
Hi allI was wondering if we can do the following on 2 BE6000's1 BE6000 will host a PUB and SUB, the other one a second SUB and UnityConnection. The FAQ, states max 2 nodes but further down it says the cluster can hold more then 3..... Thanks in advan...
3 device pools (3 departments)need 3 different MoH, how do I attach the streams to the device poolthink this is clear to me at leastso DP A, has MRGL A, MRGA... now how can I attach stream A to this
so reading this correctly we use the priority to change the order, but what if there are more then 4 streams (since this is a pilot setup, but I heard that the customer wants to extend this to other sites)
