08-13-2012 10:17 AM - edited 03-16-2019 12:41 PM
Hi, we just installed a new gateway, is MGCP and its registering OK in a call manager 5.1, with 4 bri interfaces, after I place a call to d DID, i can see the call going trough the call manager, but when I pick up the phone i got fast busy signal
any idea?
thanks
Cesar
08-13-2012 10:20 AM
This is the SH Run
ESSAFE5CR0068#sh run
Building configuration...
Current configuration : 6131 bytes
!
! Last configuration change at 16:43:07 UTC Mon Aug 13 2012 by Admin$00
! NVRAM config last updated at 16:43:08 UTC Mon Aug 13 2012 by Admin$00
!
version 12.4
no service pad
service tcp-keepalives-in
service tcp-keepalives-out
service timestamps debug datetime localtime
service timestamps log datetime localtime
service password-encryption
!
hostname ESSAFE5CR0068
!
boot-start-marker
boot-end-marker
!
enable secret 5 $1$6sAi$cC9yBlqokn.1Y43/hQF2w0
enable password 7 153F0A02052D2E366C6365
!
aaa new-model
!
!
aaa authentication login default local-case
!
aaa session-id common
network-clock-participate wic 0
network-clock-participate wic 1
!
!
ip cef
!
!
ip domain name logistics.es.dhl.com
ip host ESCXQ1WS025 2.14.8.25
ip name-server 2.14.8.20
ip name-server 2.14.9.21
isdn switch-type basic-net3
!
!
trunk group PBRI
max-retry 2
voice-class cause-code 2
description Lineas RDSI
hunt-scheme round-robin
!
voice-card 0
no dspfarm
!
!
!
!
!
!
!
!
!
!
!
!
username cisco privilege 15 password 7 110A1016141D
username DHL privilege 15 password 7 03005307
username Admin$00 privilege 15 password 7 062B0E2F4D490C0B414742
!
!
!
!
interface FastEthernet0/0
ip address 2.14.116.68 255.255.255.224
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface BRI0/0/0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn bind-l3 ccm-manager service mgcp
isdn static-tei 0
trunk-group PBRI
!
interface BRI0/0/1
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn bind-l3 ccm-manager service mgcp
isdn static-tei 0
trunk-group PBRI
!
interface BRI0/1/0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn bind-l3 ccm-manager service mgcp
isdn static-tei 0
trunk-group PBRI
!
interface BRI0/1/1
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn bind-l3 ccm-manager service mgcp
isdn static-tei 0
trunk-group PBRI
!
ip route 0.0.0.0 0.0.0.0 2.14.116.65
!
ip http server
!
logging trap notifications
logging facility local5
logging 2.14.8.67
snmp-server community DSC_mng_rd RO
snmp-server community DSC_mng_wr RW
!
!
!
control-plane
!
!
!
voice-port 0/0/0
compand-type a-law
cptone ES
!
voice-port 0/0/1
compand-type a-law
cptone ES
!
voice-port 0/1/0
compand-type a-law
cptone ES
!
voice-port 0/1/1
compand-type a-law
cptone ES
!
ccm-manager fallback-mgcp
ccm-manager mgcp
ccm-manager music-on-hold
ccm-manager config server ESCXQ1WS025
ccm-manager config
!
mgcp
mgcp call-agent ESCXQ1WS025 2427 service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
mgcp rtp unreachable timeout 1000 action notify
mgcp modem passthrough voip mode nse
mgcp package-capability rtp-package
no mgcp package-capability res-package
mgcp package-capability sst-package
no mgcp package-capability fxr-package
mgcp package-capability pre-package
no mgcp timer receive-rtcp
mgcp sdp simple
mgcp fax t38 inhibit
mgcp rtp payload-type g726r16 static
mgcp bind control source-interface FastEthernet0/0
mgcp bind media source-interface FastEthernet0/0
!
mgcp profile default
!
!
!
dial-peer voice 1 pots
trunkgroup PBRI
description Llamadas entrantes SRST
translation-profile incoming pstn-in
incoming called-number .T
direct-inward-dial
!
dial-peer voice 100 pots
trunkgroup PBRI
description Llamadas salientes SRST
translation-profile outgoing pstn-out
destination-pattern 0[689]........
forward-digits 9
!
dial-peer voice 101 pots
trunkgroup PBRI
description Llamadas salientes SRST
translation-profile outgoing pstn-out
destination-pattern 000T
!
dial-peer voice 102 pots
trunkgroup PBRI
description Llamadas salientes SRST
translation-profile outgoing pstn-out
destination-pattern 00[1689].
forward-digits 3
!
dial-peer voice 103 pots
trunkgroup PBRI
description Llamadas salientes SRST
translation-profile outgoing pstn-out
destination-pattern 0112
forward-digits 3
!
dial-peer voice 104 pots
trunkgroup PBRI
description Llamadas salientes SRST
translation-profile outgoing pstn-out
destination-pattern 0118..
forward-digits 5
!
num-exp 961794819 31820
num-exp 961788944 31816
num-exp 961767609 31817
num-exp 961795948 31818
num-exp 961796016 31819
num-exp 961781105 31814
num-exp 961785308 31821
num-exp 961783939 31810
num-exp 961783928 31811
num-exp 961767585 31812
num-exp 961788959 31813
num-exp 961767027 31815
num-exp 961795251 31822
num-exp 961795814 31823
num-exp 961780168 31824
num-exp 961780333 31825
!
call-manager-fallback
max-conferences 4 gain -6
transfer-system full-consult
ip source-address 2.14.116.68 port 2000
max-ephones 30
max-dn 60 dual-line
keepalive 10
no huntstop
time-format 24
date-format dd-mm-yy
!
banner motd ^CCCCCCC
------------------------------------------------------------
// Esta usted accediendo a una maquina con control de //
// ataques exteriores. //
// //
// Si no tiene la debida autorizacisn del departamento //
// de comunicaciones, cierre su conexion inmediatamente. //
// //
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
// You are trying to access to a device with external //
// attack control. Please, disconnect inmediately if you //
// are not authorized. //
// //
************************************************************
^C
!
line con 0
line aux 0
line vty 0 4
session-timeout 5
timeout login response 15
privilege level 15
logging synchronous
length 0
transport preferred telnet
transport output telnet
line vty 5 15
session-timeout 5
timeout login response 15
privilege level 15
logging synchronous
transport preferred telnet
transport output telnet
!
scheduler allocate 20000 1000
ntp clock-period 17179994
ntp server 2.14.8.249 prefer
ntp server 2.14.8.250
!
end
08-13-2012 10:33 AM
If the phone rings, I think the signaling is correct.
Do you have MRLG assoicated to this new gateway?
I think is something with the audio codec,
hope this help to you.
Regards!
08-13-2012 10:37 AM
Configure the trunks with a-law instead of default u-law.
Chris
08-14-2012 12:17 AM
So far everything looks fine, after doing mgcp events debug this message showed up
Failed to create voice call leg, rc = -25!
https://supportforums.cisco.com/thread/285117
we are running an old ios version, so we will try the upgrade and let you know.
regards
Cesar.
08-14-2012 08:06 AM
an IoS update fixed the issue, but thatnks for your help anyway
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide