No conference Bridge

[cvicentep]

Hi... when i try to realize a conference in the phone show me this message "No conference Bridge"

[Rob Huffman]

Hi Carlos,

Here are some good guides that will help you get this setup;

Cisco CallManager System Guide, Release 4.1(3)

Conference Bridges

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edae2.html#wp91541

Adding a Software Conference Device

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803ed6a4.html#wp1023972

Adding a Hardware Conference Device

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803ed6a4.html#wp1038602

Hope this helps!

Rob

Please remember to rate helpful posts.....

[e.huntley]

Also make sure you have your conference bridges in an MRGL assigned to your device pool(s)

[espereir]

Did you check if you have a Conference bridge configured on CCM?

Also, if you are running out of software conference sessions, you can increase them, just go to service >> service parameters and select the server and the Cisco IP Voice Media Streaming App service, there you will see the conf session number.

[shamkumar]

Thank you so much it worked...thanks again and keep rocking......