05-06-2016 12:20 AM - edited 03-18-2019 11:58 AM
Hi everyone,
I've configured a basic configuration for the VG320 analog gateway, ive copied pasted the running config in the gw.
I'm not able to login anymore because i cannot retrieve the password.
Is there a possibility to do a password recovery?
Solved! Go to Solution.
05-06-2016 12:33 AM
Plz check this, it applies to VG3XX as well
http://www.cisco.com/c/en/us/support/docs/routers/2600-series-multiservice-platforms/22188-pswdrec-2600.html
Manish
05-06-2016 02:48 AM
Hello,
Edit: Connect console cable directly with laptop and VG350 then perform below steps for recovery of password
1) Power off the router
2) Turn it back on
3) Break into rommon
4) Enter "confreg 0x2142"
5) Enter "reset"
6) An empty router will come up
7) Enter "copy startup-config running-config"
8) This will load the usual configuration of the router into NVRAM
9) Change the passwords as required.
10) Enter "conf t" then in global config enter "config-register 0x2102"
11) Write to memory
11) Reload router and test password.
Br,
Nadeem Ahmed
05-06-2016 12:33 AM
Plz check this, it applies to VG3XX as well
http://www.cisco.com/c/en/us/support/docs/routers/2600-series-multiservice-platforms/22188-pswdrec-2600.html
Manish
05-06-2016 02:48 AM
Hello,
Edit: Connect console cable directly with laptop and VG350 then perform below steps for recovery of password
1) Power off the router
2) Turn it back on
3) Break into rommon
4) Enter "confreg 0x2142"
5) Enter "reset"
6) An empty router will come up
7) Enter "copy startup-config running-config"
8) This will load the usual configuration of the router into NVRAM
9) Change the passwords as required.
10) Enter "conf t" then in global config enter "config-register 0x2102"
11) Write to memory
11) Reload router and test password.
Br,
Nadeem Ahmed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide