08-09-2012 11:08 PM - edited 03-16-2019 12:38 PM
need some help here
i already configured CUCM and UCCX for Auto Attendant when i tried to call the trigger number from internal phone i can call the trigger number and hear the auto attendant.
when i call the trigger number from outside(pstn) it always failed to connect , but when i call the other extension except the trigger number it can connect.
here my config on the router
voice-port 0/0/0
supervisory disconnect dualtone mid-call
cptone ID
timeouts interdigit 2
timeouts call-disconnect 0
connection plar 3210
(3210 is the trigger number,when i tried to call 200 it success but 3210 always failed)
dial-peer voice 201 voip
destination-pattern [1-9]...
progress_ind setup enable 3
progress_ind alert enable 8
progress_ind progress enable 8
progress_ind connect enable 8
session target ipv4:10.7.35.3
thank you for your time
Solved! Go to Solution.
08-10-2012 06:50 AM
Sounds like CSS/PT issue. You need to ensure the Partition assigned to the cti ports and route points are listed in the CSS of the Gateway.
HTH,
Chris
08-12-2012 07:33 PM
Hi Yopie Lianto,
Could you please also ensure that the Route Point and the Call Control Group which are associted with the UCCX application are using the above PT. Please attach the sanpshots of the same from UCCX box.
Thanks,
Anand
08-10-2012 06:50 AM
Sounds like CSS/PT issue. You need to ensure the Partition assigned to the cti ports and route points are listed in the CSS of the Gateway.
HTH,
Chris
08-11-2012 10:59 PM
hmm..
i already do that..
i use internal_PT(internal partition on my CTI route point) and in the gateway i use Platinum_CSS which contains all the partiton that already i create.but still failed.when i call i got one nomal tone and then busy tone for the rest
08-12-2012 06:38 AM
You did not say what PT is assigned to cti ports. That PT needs to be in CSS of the GW.
Sent from Cisco Technical Support iPhone App
08-12-2012 07:06 PM
the CTI port i create using the same PT with CTI_routepoint which is internal PT.
08-12-2012 07:33 PM
Hi Yopie Lianto,
Could you please also ensure that the Route Point and the Call Control Group which are associted with the UCCX application are using the above PT. Please attach the sanpshots of the same from UCCX box.
Thanks,
Anand
08-12-2012 07:47 PM
the route point in CUCM and Call Control Group in UCCX use the same PT.
here some snapshot from UCCX.
08-13-2012 03:21 AM
Thanks for your time..
finally i can solve the problem.
the problem:
1. all the CTI_port must be associate with jtapi and RMCM aplication user
2. command codec g711ulaw on router
thank you..
08-13-2012 06:46 AM
1. Not needed
2. Yes, UCCX is installed with sigle codec, so either ensure calls arriving to UCCX use the codec installed, or use transcoders.
HTH,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide