The service provider seems to reject the call.
Feb 23 13:31:44.954: ISDN Se0/0/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0x80E2
Cause i = 0x8195 - Call rejected
Likely because of that the calling number does not belong to your range of DDI numbers. This is very common. You would need to modify the calling number to be within the range of DDI you have for the circuit.
As @Roger Kallberg mentioned, the disconnect is from ISP with cause Call rejected. you need to check with them why they reject the call.
Calling Party Number i = 0x2181, '22278888' if this doesn't belong to your DID block ISP will block the call for billing purpose.if not from your DID block You need to translate the calling to use from your DID block. it should work with 22278824.
Plan:ISDN, Type:National
Called Party Number i = 0xA1, '57550551'
If 22278888 belongs to your DID, ISP wont reject the call.
Incoming call
Calling Party Number i = 0x2181, '57550551'
Plan:ISDN, Type:National
Called Party Number i = 0x80, '22278824'
Plan:Unknown, Type:Unknown >>> type is unknown from ISP
Outgoing call send type National, change the type to unknown from RP and try.Most probably your call should work, as i faced similar issue with an ISP here in oman.
Calling Party Number i = 0x2181, '22278888'
Plan:ISDN, Type:National
Called Party Number i = 0xA1, '57550551'
Plan:ISDN, Type:National
If you are using SRST in the gateway I would recommend you to set the type in the gateway instead with the voice translation rules. Otherwise you would get the same problem when the phones goes into SRST mode. Rule of thumb that I tend to use is do any transformation of calling and called numbers as close to/from the source as possible. In general this would mean that there is no, or at least minimum needs to do it in the CM and you have one place for the site to maintain this.
No, but if you do a change on the gateway configuration object in CM you do need to reset it for the change to take effect. Please share the configuration you did so that we can verify it.
Your first screenshot is from the RP I assume. If so you are changing the type for called number, aren't the telco rejecting the call based on calling number being wrong? Second screenshot is from what I can tell from the gateway element, there you are setting the number type for called and calling numbers to National and number plan to Unknown for called and ISDN for calling. FYI This would override what you set on the RP level, you don't need to specify this on multiple places.
Instead of doing this in CM I suggest that you do it in the gateway instead with this.
voice translation-rule 100 rule 1 /^\(222788..\)$/ /\1/ type any unknown plan any isdn rule 2 /.*/ /22278888/ type any unknown plan any isdn
Better contact ISP and find out which filed make them to reject the call. Or keep both calling/called unknown and try.
