07-06-2021 12:45 PM
Hi,
I have route plan 9.[25478]XXXXXX for outbound PSTN calls with predot enables
created a sip trunk to call route between non-cisco PBX and cucm .
i can call between extension PBX(3XXX) nd CUCM(7XXX)
Now I want to initiate a call 9.2XXXXXX from 3XXXX.
What Pattern should I sent to CUCM
Thanks
07-06-2021 12:57 PM
hi there
You have to create a new pattern (without any digit strips) in non-Cisco PBX , the points to CUCM SIP Trunk. Once the call reaches CUCM, it will stip 9 and use the 9.[25478]XXXXXX Route pattern
Hope this Helps
Cheers
Rath!
***Please rate helpful posts and if applicable mark "Accept as a Solution"***
07-06-2021 11:30 PM
It depends on you. From PBX You can send with 9 or without 9.
If you send the call with 9,your call will match with your CUCM RP 9.[25478]XXXXXX . CUCM will strip the 9 and send it to Your ISP.
From PBX if you dont want to send 9, on CUCM create a new RP [25478]XXXXXX and keep this RP in a new partition. And assign inbound CSS on TRUNK which can access this new RP.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide